Question about 2007 Ford Edge SEL Plus

Open Question

Had my 2007 Ford Edge in for it's second PTU seal leak. Now the vehicle pulls to the right when driving. Dealer states it had nothing to do with the recent repair. Could this pull have anything to do with the seal being replaced?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 92 Answers

SOURCE: pinion seal leaking

check your rear diff vent if pluged clean it out and clean up the pinion seal.sometimes if the leak is caused by pluged vent and has not been leaking long once vent is clean sometimes the leak will stop.there is not a specific torque amount because it is rotational torque(how hard to turn pinion).there is a crush sleve on the pinion and if torqued too tight or too loose brg preload will be wrong and brg damage could result.mark and remove drive shaft.remove rear wheels,brakes,axles.so when turning pinion you dont have any drag from brakes or axles.mark the position of the yoke on the pinion.remove yoke,replace seal,reinstall yoke be sure to replace pinion nut.tighten nut until it takes the exact same amount of force to turn pinion as before taking original pinion nut off.hope this helps.

Posted on Oct 22, 2008

  • 124 Answers

SOURCE: leaking front axel seals on 2006 gmc 2500 4x4 hd

There should be a big nut in the center of the wheel hub. You will have to remove atleast one of the ball joints if it's IFS.

Posted on Mar 28, 2009

  • 6982 Answers

SOURCE: Rear drive shaft seal leaking

Yes, but you will need to mark the yoke position and exact number of turns to remove the nut or you will change ring and pinion gear lash setting when re-installing it. You can use a large pipe wrench to hold the yoke still while tightening, or get a special tool made for that.

Posted on May 04, 2009

  • 304 Answers

SOURCE: Rear Axel Seal Leaking, How do I pull the axel to repair?

You will need to remove the differential rear cover,drain fluid, remove wheel, brake drum, (rotor) . Unbolt center diff. pin, carefully remove (don't loose shims) push axle in remove lock keeper, then slide out axle, replace seal, put some grease on it, slide axle in reverse all to install.

Posted on May 22, 2009

  • 1 Answer

SOURCE: 2007 Jeep Liberty 3.7L engine

the dash lights will not come on and now my right parking light is out and i replaced the bulb and still nothing. HELP PLEASE

Posted on Jul 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2007 ford edge brakes are so hard that the car want hardily stop unless I press ******* brakes. I bleed the brakes and still doing it. What is this?


have the brake pads and disks checked immediately

also have the servo looked atm you need to do this before driving the vehicle ....it is a hazard to yourself / family and other road users.



You say you have bled the brakes why?
Have you checked the wheel cylinders are not leaking brake fluid on the pads which might be why the vehicle is not stopping

Jun 24, 2015 | 2007 Ford Edge

3 Answers

I have 04 vue. Fwd 3.5. How do i change out right side cv axle? I can't free end that goes into carriage bearing?


remove lower ball joint and remove axle nut in the center of spindle. then move the spindle out of the way separating the axle from the spindle.

Mar 28, 2015 | 2004 Saturn VUE

1 Answer

Crankshaft oil seal


ring your ford dealer and give him the vehicle details and they will find the right seal that you need or you can ring a bearing and seal supplier in your area and give them the details of your car, they are most probably a lot cheaper too.

Oct 03, 2013 | Ford Escape Cars & Trucks

1 Answer

Hi, I have a 2007 Edge SEL Plus, and after highway driving and coming to a stop at traffic lights I smell burning oil and see a little smoke coming from under the hood, I only have 28k on the vehicle and...


Either you have an oil leak dripping onto the exhaust or an engine breather pipe is loose or ruptured. Eitherway have these checked out as they pose one or both of a fire or health hazard.

Jan 16, 2011 | 2007 Ford Edge SEL Plus

2 Answers

Rear oil seal leaking. how to fix


If your sure the rear main seal is leaking then the engine and transmission have to be separated. It is easier to remove the transmission. If it's an automatic then after trans removal, you have to remove the flex plate to expose the seal. If it's a manual then the flywheel has to be removed after trans removal. It is a one piece seal that can be pryed out gently and a new one pressed in.

Jan 08, 2011 | 1991 Chevrolet S-10 Blazer

1 Answer

Front right differential seal is leaking. Is it much to repair? Is it something that I could do myself with limited mechanical ability? Approx. how much should it cost at Ford to do. Is there an...


You mean the axle seal is leaking if it is not the one that is for the driveshaft. If you have limited mechanical ability I would recommend that you take it to a shop to have it repaired. There are special tools that are used to drive the seal back in and if you're not careful when installing it the new one could leak as well. As for time to repair it, book time for the right front axle seal is 1.3hours to remove and install the axle and .2hours to replace the seal. So 1.5 hours times the shop rate is what it will cost you, and shop rates vary so shop around. Check your Ford dealer also it could be warranty, I believe Fords warranty is 3 years 60 000 kms so you still might have warranty for it. Also I personally don't ever like to use stop leak additives for anything, its best to just fix the problem. Those things sometimes cause more problems than they're worth.

Good Luck, if you have any more questions please ask.

Dec 23, 2010 | 2007 Ford Explorer Sport Trac

4 Answers

Driver side floor water leak in 2007 ford edge. Looks like it's coming from the dash area. Any ideas? Tks.


Well, you are on the right path; the rubber seal around the windshield could indeed be deteriorating...what may be happening is the water is coming through the cowling and pooling up on the seal there...as the water sits, the seal deteriorates and eventually you will see water like you are now.

My recommendation to you is to take your Edge to a shop and ask them to look for a leak at the bottom seal of the windshield.

Oct 14, 2009 | 2007 Ford Edge SEL Plus

1 Answer

My main dealer has indicate that I have a slight oil leak from the rear differential - they say that the whole unit require sto be replaced and that you cannot replace the oil seals - the car has only...


I say get a second opinion on how bad the oil leak is. The dealer should be willing to cover some of the cost as the vehicle has not done that many miles. A Continental with that many miles should not leak! I think they might be trying to take your money. Buy a cheap white sheet and park the car on top of if after a decent trip and see what is there in the morning. if nothing dont stress about it.

Aug 06, 2009 | 2007 Bentley Continental GT Coupe

Not finding what you are looking for?
2007 Ford Edge SEL Plus Logo

Related Topics:

649 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...