Question about 2004 Mazda 3

1 Answer

My mada 3 2006 randomly decides it doesnt want to start, but anywhere from 30 minites to hours later it decides it does want to, it recognizes the key , but wont let me turn the key to the start position on the ignition..... its getting old.... any one heard of this?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

Try turning steering wheel and then turn ignition. It should work, if not, the ignition cylinder may need to be changed out.

Posted on Nov 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

07 hyundai sonata limited with v6 engine has a knocking sound every time u start it but then 30 seconds later it smooths out & u dont hear it again until next time u start it.


try going up a grade in viscosity ( from 15 w to 30 w)
ensure that only quality filter is used with an anti drain back valve in the filter El cheapo units miss this valve
possible worn hydraulic followers are allowing oil to drain back when stopped and it takes a few seconds to build up oil pressure

Apr 02, 2018 | Hyundai Cars & Trucks

1 Answer

My relay keep blowing bad its keeping my car for


the relay command starter signal small wire at starter look at the relay youll see numbers at the legs side 30 87 are your contacts 85 86 are the relay coil make sure all contacts are clean when car wont start hook test lit between 85 86 should lit up next join 30 87 use a piece off wire car should crank if doesnt check power at pin 30 o 87 one must be hot if every check pass replace starter solenoid

Sep 27, 2014 | Cars & Trucks

1 Answer

Bmw 318ti Just randomly cuts out and doesnt start


check for trouble codes and have the fuel pressure tested.

Sep 05, 2017 | 2002 BMW 3 Series

1 Answer

Subaru Legacy 1995, will not start. Battery is fine, replaced battery connections; fuel filter, spark plugs and wires about 1 year old. Engine turns over and over, and over, just can't get it to ''fire,''...


was the check engine light on? have it scanned for a code if it was. remove the timing cover just enough to peek and just make sure the timing belt isnt broken. do you smell gas coming out of the exhaust while cranking the engine for 10 seconds? if not it could be gas related. or pull one of the plug wires off a spark plug and hold it a 1/4 inch or a little less away from the engine ground (ANY METAL PART OF THE ENGINE)see if it archs while cranking for 5 seconds, if it does not arch suspect that the camm and or crank sensor is a bad. PLEASE NOTE: this information is based on what you have told me. however if you have it scanned and give me the code pulled i will be better equipped to help you. if u run the tests i gave you and come up with nothing you may have to take it to your local technician for more complex tests to be done.

Jul 21, 2010 | 1995 Subaru Legacy

1 Answer

Randomly dies and randomly won't start


check fuel pump in tank could be overheating and going bad they have a thremal sensor that shuts the pump off to prevent a fire

Mar 10, 2010 | 1991 Buick Park Avenue

1 Answer

Audi tt sometimes doesnt start almost like it has immobolised itself. then if i leave it it may start a couple of hours later. or if i just hold the ignition in start it may fire up after 20 - 30 secounds...


If this is a security issue you will have a code stored. Best bet is to get the PCM data and codes before doing anything else. If you don't have the knowledge or information to work on this car there is no way for the home mechanic to do anything.

Jan 14, 2010 | 2000 Audi TT

1 Answer

Doesn't always start, dies as I'm driving


sounds like you need a new fuel pump.

Oct 02, 2009 | 1998 Honda Accord

1 Answer

99 vr6 eurovan engien dies when hot but minits


sounds like its the water pump needs changeing

Aug 14, 2009 | 2004 Volkswagen Eurovan

Not finding what you are looking for?
2004 Mazda 3 Logo

Related Topics:

137 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...