Question about 1995 Chevrolet Blazer

2 Answers

Have to prime to start. missing . have to press accelerater really slow or will die.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 134 Answers

This maybe be due to a clogged fuel filter aslo under the upper plenum(intake) there is and fuel dist. it has six plastic lines coming out of it they are known to crack and break ( vortec v6 ) if the filter is not the problem and you have plenty of fuel pressure coming out of the line i whould get those lines.

Posted on Nov 12, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 165 Answers

Sounds like not enough fuel pressure. could be the pump getting weak. (common problem) or the filter may be plugged up. the filter is the cheapest.
Hope this helps

Posted on Nov 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The car starts but dies as soon as you put your foot on the accelerater and then won't start again. The battery is fine and it's not the timing belt any suggestions please?


Sound like fuel problem,Vehicle needs a set amount of pressure to spay out of the injectors,this atomization ensure proper comustion,If it was MAF(mass air flow) obviously you would be able to restart,but would complain about hesitation,When you step on the gas you apply a load on the engine and a good working fuel pump ensure it meets that load3_17_2012_7_10_37_pm.jpg

Mar 17, 2012 | Cars & Trucks

1 Answer

1996 chevy k1500 runs when idleing slight miss drives down the road fine but when comming to a stop it dies


When the light flashes it means a cylinder misfire, so you must check everything, spark, (first) injector fuel delivery intake manifold vacuum leaks and compression if not other problem accounts for the misfire.

Feb 04, 2012 | Chevrolet 1500 Cars & Trucks

1 Answer

In the morning when i start my 1999 mazda 626. the accelerater run really slow and usually when i make a full stop. when the engine get hot it run better. how can i fix the problem. thank


Try cleaning the Idle Air Control motor and it's internal housing with carb cleaner. You will need to remove the IAC to do this. It is located on the throttle body and usually has four wires going to it. Be gentle with IAC, use a toothbrush inside housing and don't spray too much inside. Open the throttle plate and clean inside while your at it. The computer may need to relearn after this, but it only takes a few minutes.

Aug 30, 2011 | 1999 Mazda 626

1 Answer

83 nissan 720 pick-up, fuel pump went out replaced ran good for a few days and stopped again. had no power to pump. so I replaced fuel pump relay switch & pump work great. I have gas to the sight bowl,...


You say you replaced the fuel pump relay switch? The fuel pump relay is located in the passenger compartment on the right side under the dash. Little black box with a 6 pin plug. Replace that and your power to the pump should be restored . Had this happen on mine just last week. The relay actually monitors the alternator, key switch and a couple of fuses and will remove power from the pump if there is a fault. AutoZone stock number is 20550, costs about $50.

Aug 06, 2010 | 1983 Nissan Pickup

1 Answer

Engine will not fire immediately when key engaged unless accelerater pumped prior to key engagment, already changed fuel filter twice


Sounds like the fuel pressure regulator is allowing the fuel pressure to bleed down. While sitting (key off) it should hold about 30 psi of fuel pressure to keep the system primed. When it bleeds down it causes an extended start, you sometimes have to cycle the key a couple of time before it will start. If this is the case then replace fuel pressure regulator. FYI pumping the accelerator on a fuel injected vehicle does not prime the system.

Nov 24, 2009 | 2003 Ford Expedition

1 Answer

Engine starts surging fast then slow--then stops


you have a accelerater sensor bad and some people call it throttle positional sensor

Feb 19, 2009 | 1999 Buick Park Avenue

1 Answer

1976 Ford F150 Bogs down when accelerater is pressed.


if it has a converter on it.....it may be stopped up, but before you replace it have the fuel pump checked, as it may not be getting enough gas at higher rpms. It will start and idle fine, but starve out when you press the pedal. Have you changed the fuel filter?That will cause the same problem.....

Jan 30, 2009 | 1983 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...