Question about 2003 Ford E-Series

1 Answer

Leaking from the pully thing that the lines run to? what is it called. 1995 chevy van,350 moter

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 174 Answers

I believe that you are talking about the power steering pump. Is it located on the bottom drivers side of the engine? If so where exactly is the leak coming from? If it's one of the lines they can be replaced, if it's from the pump itself or the reservoir it's probably a seal on the end of the pump shaft. You can replace that but you need some special pullers to disassemble the pump. It might be easier for you to just buy a replacement one form a parts store. Lines are pretty easy to replace, just take the faulty one in and have them order the correct one.

Posted on Nov 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Torque specs of moter mounts of 350 chevy


63 lbs-ft. biggest thing to make sure of is that they are tight. You really don't need to torque to a specific torque. But the specs are here for your needs.

Nov 10, 2016 | Chevrolet Cars & Trucks

1 Answer

2000 chevy express 3500 van with a 350. Hard time starting. When it starts runs beautiful! Will only start after several taps of the key as if you where setting timing. Not with key fully turning over....


sounds like the check valve in fuel pump is allowing fuel to drain back out of lines. this would require ystem to prime up each time it is cranked. check fuel pressure it should hold with key off if it leaks down this is problem and pump will need to be replaced

Jun 06, 2011 | 2000 Chevrolet Express Cargo

1 Answer

How to locate a vacum leak under load [going up hill] on a 2006 express van with 4.3 moter


only thing i can suggest is while the engine is cold have someone run up the rpms and spray carb cleaner around the vacuum lines and anywhere else you think there could be leak. if a leak is present the engine will **** up the carb cleaner and bog down. BE SURE TO DO THIS WITH THE ENGINE COLD CARB CLEANER IS FLAMMABLE.

Apr 18, 2011 | 2006 Chevrolet Express

1 Answer

Is base timing automatically set by the ecu on a 99 chevy astro van. Did a intake gasket (upper and lower) job. Now van runs like the timing is off. What's the correct advance number?


You may be one tooth off on the distributor. With the cap off and battery disconnected rotate the engine to the small timing mark in the crank pully. There should be a small line in the pully and a single finger or mark on the timing cover. Now look at the distributor. The rotor should be in line with the 6 molded into the plastic. Hope this helps!! I was one off after doing intake gaskets and this is what helped me.

Dec 24, 2010 | 1999 Chevrolet K1500

1 Answer

I have a 1995 Chevy Van with a 4.3 liter, it's a CMFI eng. I have 2 fault codes 32 and 83, I changed the IAC vavle which is fault code 32. I do not know what 83 is, but the fault codes as the IAC vavle is...


i dont know what that code is but i do know that those enigines have a bad problem with fuel leaks under the upper intake what happeins is the plastic type line that go to your injectors crack or just break and then they leak and then the van runs like poo. if you take the 30 min it take s to get the upper intake off to inspect the lines for leaks if there are broken line or bad o-rings you can buy that whole injector kit. its pretty simple. this is some thing that i would check. good luck.

Jan 26, 2010 | 1995 Chevrolet Astro

3 Answers

1979 chevy step van 350 new fuel pump rebuilt carburetor wont sta


remove the fuel line from the carb, put it into a bottle, crank the engine, If the bottle has fuel in it the fuel pump is working properly, if not, check the filter, and the fuel lines to the tank!!!

Nov 02, 2009 | 1979 Chevrolet C/K 3500

2 Answers

Chevy 350 express van 2000 runs great idles rough


If it does not do it in park or neutral, it could be a number of things. One being a sticking Torque Converter Clutch solenoid (TCC). It could be that it needs a simple tune-up. How often does this problem happen?

Jun 29, 2009 | 1996 Chevrolet Suburban

1 Answer

What's it called?


It would be called the engines accessory pulley mounting bracket

May 23, 2009 | 1987 GMC VanDura

1 Answer

Belt change for 1995 chevy g20


there should be a diagram sticker under the hood . first thing check to make shure all accesories move freely no locked pullys that may have shot the belt to begin with

Apr 04, 2009 | 1993 Chevrolet G20

Not finding what you are looking for?
2003 Ford E-Series Logo

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...