Question about 1990 Honda Accord

2 Answers

Buzzing noise coming from abs unit on start up, when he noise stops the abs light comes on ?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 448 Answers

The light indicates a malfunction in the ABS (ALB) system. First, I would check your brake fluid level in the ABS unit (see pic, similar, I think). It should be between the max and min levels indicated on the front face of the reservoir. You should also check your regulator brake fluid reservoir to make sure the level there is correct. Dot3 or Dot4. If that is not the problem, then wheel sensors would be suspect, but that would be a Honda service indication.
Hope this helps you.buzzing noise coming from abs unit on start up, - 75b78f9.jpg

Posted on Nov 12, 2009

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

POSSIBLE RELAY

Posted on Nov 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Traxtion and ABS lights come on at same time and noise come from front area of car. What does this mean?


Depending on what car you have. It's as though you have an abs ring/sensor fault, the noise you are hearing is the abs pump working this is because the gap between the abs sensor and the abs ring is to close, which make's the abs control module think that the wheel has locked up. causing it to open the valves in the abs hydro unit to try take away the pressure from the side with the fault.

Oct 18, 2016 | Cars & Trucks

1 Answer

Why does my abs makes a noise when engine is off


Your ebcm internal relay is likely failed, possibly has a c0265 code in ebcm. Pull the abs maxi-fuse underhood fuseblock, abs and red brake light will come on, but noise should stop. There are several module rebuilders online (module masters comes to mind)

Apr 02, 2015 | 2001 Chevrolet Tahoe

1 Answer

Eb abs trouble


howdie sounds like their could be abs module week or you could have a sensor wire broke on one of the wheels, or the master cly could have a leak does the pedal come bk up right away?ck this out if not get a quote from your local garage its not good to mess around with brakes

Jul 24, 2012 | Ford Falcon Cars & Trucks

1 Answer

Abs light came then a winding noise


the abs valve assembly is under the drivers seat mounted on the frame if a gear went bad it will keep trying to move the valves it has a electrical plug on it and you will see all the brake lines go in and out of it

Jul 01, 2012 | 2004 Chevrolet Silverado

1 Answer

Load noise from engine compartment when brakes applied and almost stopped


This sounds like the abs system is coming on, this may be due to a bad wheel sensor, the best way to see if the noise is the abs is to remove abs fuse and drive, the abs light will come on but drive to see if noise is gone. by removing the fuse the system will shut down. the way it makes noise when close to a stop means the abs could be the noise, a bad sensor at the wheel would cause this. it looses the signal for a sec or two and the compuetr thinks the wheel is skidding and the rest are moving, so the noise you hear is the abs unit release the wheel. if the abs is the problem then the next step is to have a garage scan the abs module for codes. the codes will tell you where the problem is and which wheel. good day.

Feb 18, 2012 | 2002 Saturn VUE

2 Answers

My honda 1993 have abs light on and sometime it has streaking noise for few minutes and stops by itself; also while noise is there lights get dimmed?


the shreiking is probably your belt, which might be loose, and the lights dimming could be the same thing, the belt loose

Dec 16, 2010 | 1993 Honda Accord

1 Answer

The ABS light is on and a buzzing noise too.


you may have to plug car up to diagnostics

Jun 17, 2009 | 1992 Mazda 929

1 Answer

ABS light comes on


Per your description, I would suspect you have a faulty wheel speed sensor. Take you vehicle to your local Auto Zone or Advanced Auto and have the codes pulled for free. Write them down and let me know what they are and we can go from there.
Good luck.
Regards,

Mar 05, 2009 | 1997 Chevrolet Cavalier

1 Answer

Abs sensor light wont go off my 2005 polo


Your ABS systems use a combination of electronic and hydraulic systems to modulate the brakes individually to prevent them from locking up. ANTILOCK systems consist of wheel speed sensors, a hydraulic control unit (HCU), and an electronic control unit (ECU). Because of how complex the system is your computer does a self-test. If the check is successful, the ANTILOCK and BRAKE lights will go out within a few seconds. If one of the component of the ABS system fails to pass one or both lights will remain lit. One or both warning lights may also come on while driving, also indicating a problem. If just the ANTILOCK warning light comes on, some ABS component has failed, but the car still has hydraulic brakes. The grinding noise could the the ABS pump or your brake pads could to worn to the metal backing and grinding against the brake rotors. I recommend a inspection soon for your safety.

Mar 04, 2009 | Audi S4 Cars & Trucks

1 Answer

Buzzing noise


check under vehicle on frame rail drivers side, should see abs assembly, disconnect red wire buzzing will stop, will have to replace assembly, will not have abs braking, will have base brakes, if red brake light comes on do not drive vehicle, have towed to repair shop

Nov 24, 2008 | 2000 GMC Yukon XL

Not finding what you are looking for?
1990 Honda Accord Logo

602 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...