Question about 1993 Lexus Es 300

1 Answer

Radiator Installing a radiator ES 300 Lexus

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 81 Answers

First drain the radiator, theres a drain **** at the bottom of the radiator. just loosen the plug and then open the radiator cap. then disconnect the upper and lower hoses, disconnect the trans lines and plug them temporarily with some spark plugs or just something to plug them with. unplug the radiator fans and remove the wire harness from the fan shrouds. then unbolt the two ten millimeter bolts holding in the radiator and remove it. then take the fan shroud off the old radiator and put it on the new one, should just be a couple ten millimeter bolts. then install in the reverse order. good luck!

Posted on Nov 14, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: RADIATOR REPLACEMENT

  • At the time of installation, please refer to the following items.
  • Start the engine, and check for coolant and A/T fluid leaks.
  • Check the A/T fluid level.
  1. Drain engine coolant.
  2. Canada: Disconnect relay block (for daytime running light system) from battery hold-down clamp.
  3. Disconnect upper radiator hose from radiator.
  4. Disconnect lower radiator hose from water inlet pipe.
  5. Disconnect A/T oil cooler hoses from oil cooler pipes.
  6. Disconnect No.1 and No.2 cooling fan connectors.
  7. Disconnect No.1 Engine Coolant Temperature (ECT) switch wire connector.

  8. Remove radiator and cooling fans assembly.
    1. Remove the 2 bolts and 2 upper supports. Torque: 12.8 Nm (9 ft. lbs.)
    2. Lift out the radiator, and remove the radiator and cooling fans assembly.
    3. Remove the 2 lower supports.
  1. Remove A/T Oil cooler hoses from radiator.
  2. Remove lower radiator hose from radiator.
  3. Remove No.1 ECT switch.

  4. Remove No.1 cooling fan from radiator. Remove the 2 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)
  5. Remove No.2 cooling fan from radiator. Remove the 3 bolts and cooling fan. Torque: 5.0 Nm (44 inch lbs.)
INSTALLATION
Installation is in the reverse order of removal.

Posted on Nov 07, 2008

  • 163 Answers

SOURCE: Lexus ES 300

Unscrew the gas cap, wait 30 sec and screw it back on making 3 clicks/cracks. Should be ok in a day or two.

Posted on May 06, 2009

  • 1 Answer

SOURCE: car keys locked in trunk of 1999 lexus es 300

1. I presume your button on the dash (which opens the trunk) is not working. You could take that button out of the dash panel and manually activate the circuit by using the wires themselves.
2. If the "valet" key doesn't fit the trunk lock, see if the keys are visible through the center back seat access 'hole', make a wire hook attached to a broom handle, etc. and try to catch the ring the key is on. If the view is blocked by other things you can't move, figure out at way to move things in the trunk so you can get something to reach the key(s). Do you have other metal keys on the same keyring? If so, use a magnet to grab the whole set.
3. Have you considered taking out the rear seat? Do the bottom seat cushion first, then the back.
4. By now you have hopefully already gotten your keys back out of the trunk, but if not I hope one of these suggestions works. MW

Posted on May 12, 2009

c17hydro
  • 2984 Answers

SOURCE: location of fuel filter on 2000 lexus es 300

The fuel filter on the ES300 is located under the hood, on the driver's side, by the fenderwell.

Posted on Jul 12, 2009

  • 3 Answers

SOURCE: 99 lexus es 300 chk engine and trac lock lite on

I had check engine light and TRAC OFF. OBD-II MIL code was P1133 which is Air Fuel Ratio Sensor Response Malfunction and scanned by AutoZone. After disconnecting the battery for 10-15 minutes, the lights went off. I cleaned the gas cap and tightened it firmly. For the last 400 miles, the lights have not come back. When scanning using Snap-on one, no code was detected. I think gas cap was the reason for the lights.

Posted on Dec 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the radiator cap on a Lexus ES 300 1996


It's not on the radiator but more likely to be in a plastic bottle somewhere above the top water line as an expansion bottle.
Look for what could be a blue cap on a bottle, usually screw top, which has a couple of pipes going towards the radiator

Oct 14, 2014 | 1996 Lexus ES 300

1 Answer

How to replace thermostat on Lexus ES 300


The thermostat is located inside the thermostat housing, which is attached to the upper radiator hose.

Sep 01, 2013 | 1995 Lexus ES 300

1 Answer

How do I change the thermostat on a 1994 LEXUS ES 300


On 1994 Lexus ES300 3.0L MFI DOHC 6cyl the Thermostat is located under hood, passenger side, upper engine area, engine end of upper radiator hose, mounted in coolant outlet housing, you need to take off this componentes to access this.

Hope helps.

Nov 22, 2010 | 1994 Lexus Es 300

1 Answer

My radiator was replaced and now my power steering won't work. Could my lines be crossed. It is a 1992 Lexus ES 300


Does you vehicle have a hydraulic cooling fan on the radiator? The hydraulic fan system is ran by the power steering. The fluid level for the power steering is full?

Jun 03, 2010 | 1992 Lexus Es 300

1 Answer

What is the spark plug gap for 2000 lexus Es 300


if im not mistaken it should be 35 thousants to be sure you can check the little white tab under the hood it should be on the shroud on top of the radiator or directly under the hood on the trim. it will tell you the gap as well as the engine size and timing.

May 07, 2010 | 2000 Lexus ES 300

1 Answer

Where is the thermostat located and how do i


Follow the top radiator hose to the housing that the hose is clamped to. Remove the housing and the thermostat will be revealed. Hope this helps!

Oct 05, 2009 | 1997 Lexus ES 300

1 Answer

Need to locate t-stat on car -lexus es 300 1993


The thermostat is located on the timing belt side belt side of the motor. Look below the alternator, there should be a metal pipe secured to the block with a 12mm bolt. The pipe is attached to the lower radiator hose.

May 24, 2009 | 1993 Lexus Es 300

1 Answer

ES 300 servicing: Lexus Dealer vs. Toyota Dealer


no there is not really a downside dealers are good it doesn't really matter who does it but lexus is more familiar with lexus vehicles than toyota because they specialize in it but something like that is simple .

Feb 12, 2009 | 2006 Lexus Es 330

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

902 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...