Question about 1995 Nissan 200SX

2 Answers

The hood was removed from a wrecked car. The car

The hood was removed from a wrecked car. The car runs. How do we reinstall the hood for temporary use?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,305 Answers

This is a two-person job. Have the bolts in hand and lift the hood over the car's front end and locate it on the hood hinges.
Place the bolts in loosely at first. You'll need to adjust them for proper fit. Open and close the hood to align and tighten the bolts when in the right spot.
Hope this is what you needed to know.

Posted on Nov 12, 2009

Testimonial: "OK, will try this, Thanks!"

Ad
  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 28 Answers

Is the hood damaged? Do you have the hinges? If the parts are there you need M8 or M6 screws and bolt the hood in place. If you can see the old marks on the hinges that is a good starting point. Bolt the hood on and lower the hood into place. If it does not have even gaps loosen the bolts just enough to move the hood in place to a better fit. And re-tightened the bolts. Keep in mind that if it needs to move only slightly and one rear corner is a good fit, keep that bolt tight and loosen the rest. This bolt holds the fit there and acts as a pivot to line the hood up. If parts are missing see a local wrecker to get a salvage replacement. If you need a latch, to hold the front of the hood, buy new.

Posted on Nov 12, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

WHERE DO i FIND THE FUSE FOR THE FUEL PUMP?


May not be your fuse the fuel pump gets power through the oil sending unit so if the engine quits because of a wreck the fuel pump will not keep running. the oil sending unit has two sides one for oil pressure the other side powers the fuel pump one side can go out leaving the other side good. The fuse will be under the hood you also have a fuel pump relay under the hood it may be bad

Nov 27, 2014 | Cars & Trucks

1 Answer

Need to take driver side rear fender off truck bed its been wrecked and needs replaced please assist thanks


You don't have a rear fender Steve,you have a driver side and passenger side,to remove,on top with hood open,remove 4 bolts,open door and there's 2 more,remove corner light with phillips screwdriver,2 screws there,then at bumper,there's one,have to get under front with a 12 mm nut driver to remove,then at top,they inter lock,lift up to unlock and remove,

Sep 22, 2013 | 1985 Nissan Pickup

1 Answer

Hood latch won't stay in locked position. Hood is 1 quarter inch high.


There should be rubber bumpers on the bottom of the hood where the latch is. They are located on either side (and ends). Screw them inward for lower closure.

Apr 29, 2012 | 1999 Oldsmobile 88

1 Answer

I had a wreck when the other driver hit me head on mostly on the front drivers side of my 2005 Nissan Altima, what should I be checking internallly or under the hood? Front axle, struts, shocks, brakes,...


What I would suggest is taking it to a dealership and have perform an inspection on the car. Let them know you were in a wreck, so they would be able to look for any frame damage, leaks, or any other damage to the car. What I would suggest is communicate with your insurance company, because one Strut alone (If you needed it) would run at least $200 in labor (If their labor rate is around $100 an hour or so).

Apr 19, 2011 | 2005 Nissan Altima

2 Answers

Car wont start after accient


no reset button,check for blown fuses or you have a bad pump if its not pumping,if it is pump there is a access pannel under rear seat for pump.no need to remove fuel Check fuses and REALEY under hood also.

Dec 24, 2010 | 1992 Honda Accord

1 Answer

99 ram 5.2 liter noise under hood got louder when rained, replaced Surpentine belt tension wheel, pully, and belt. noise is still there.


If your belt is still squealing then you have a pulley contaminated with oil or coolant which will just cause it to keep squealing. Do not use a belt dressing as they are temporary and ruin the belt. Remove you belt and scrub the ribs of the belt with a mild soap. Then scrub off all the belt pulleys and rinse. Reinstall the belt and your problem should go away.

Dec 03, 2010 | 1999 Dodge Ram

1 Answer

How do I change tire on 2006 jeep


The owner manual will tell you the jack location and the jacking points. Loosen the lugnuts half a turn before you jack it up. Jack it up and remove the nuts. Put on the spare, and reinstall the nuts and run them down. Lower the car and tighten the nuts as tight as you can get them. Then drive the car to a tire shop. The spare is a temporary spare.

May 16, 2010 | 2006 Jeep Grand Cherokee

1 Answer

We need a diagram to replece the serpentine belt on a 1996 Chevy Cavalier. The decal on the hood is missing.. and yes, we should have drawn a diagram before removing!


easiest solution,go to local car lot find same year and model,open hood copy diagram,or wrecking yard if old enough,or local parts house may have diagram in manual.

Jun 16, 2009 | Chevrolet Cavalier Cars & Trucks

Not finding what you are looking for?
1995 Nissan 200SX Logo

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...