Question about 1990 Buick Century

1 Answer

Where is the starter motor on a 1990 Buick Century 3300?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Buick Master
  • 75,235 Answers

FRONT BOTTOM OF THE ENGINE AT THE BELL HOUSING OF THE TRANSMISSION, U REACH IT FROM UNDER THE CAR.

Posted on Nov 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does 1990 buick century use shims for starter, and whats best way to take out the back broken starter bolt.


it depends if the starter makes a noise or seems to be sticking when engaged shims were used. to remove a broken bolt you'll need an easy out and probably need to heat the area after drilling out the the center of the bolt

Jul 30, 2012 | 1990 Buick Century

1 Answer

1990 Buick Century Custom 4-Dr Sedan 3300 V6. New motor, fuel pump, fuel filter, alternator and starter. Turns over, though it won't fire.


Check your fuel pressure at the schraeder valve that is on the fuel rail. If you have fuel pressure, check for spark.If no spark, then ignition diagnosis is needed.If no fuel pressure, check for diconnected, or pinched wires, as this can easily happen during an engine swap.

Aug 14, 2011 | 1993 Buick Century

1 Answer

1990 Buick Century Limited wont start, but makes a click sound under hood on drivers side when you turn the key. But no battery noise. Battery measures a 11.50-12.00 . 154xxx miles Thank you


Check for power at the starter on the large wire. There should be battery voltage at all times. Next check for power on the small wire at the starter. There should be twelve volts with the key in the crank position. If both of those check out you need a starter.

Jan 26, 2011 | 1990 Buick Century

2 Answers

I need to find the coolant temperature sensor on a buick 3300


the coolant temperature sensor is located at the top RH end of engine,below generator.

May 18, 2010 | 1990 Buick Century

1 Answer

Where is the solenoid at on the 1990 buick century


The starter solenoid is located on the starter, and the starter is bolted up underneath the vehicle to the passenger side of the engine block next to the oil pan.

May 05, 2010 | 1990 Buick Century

1 Answer

How do I replace the starter in my 1990 Buick Century?I have taken off all the bolts so far but there might be another that I cannot see? Is anyone else familiar with this problem? One of the bolt was...


their should be 3 bolts holfing the starter motor onto the gearbox then at the other end of the starter motor check their is no bracket holding it onto the gearbox at the other end this might be whats causing your problem if not then pry the starter off with a screwdriver and hammer it might just be stuck tight.
If it does not move at all then you need to check their are no bracket at the end where the wires go onto the starter as one of the studs the wires go onto their might be a bracket witch will need undoing not only from the starter but also form the gearbox itself so as to give you enough room to pull the starter out.

Let me know if you need further assistance ok

Aug 17, 2009 | 1990 Buick Century

1 Answer

Is it difficult to change the motor for the window in a 1990 buick century


You will need a good pair of 45 degree long neck needle nose pliers to remove the clips for the motor arms, and yes it can be a bit trying of ones patience and mechanical skill level.

Jul 14, 2009 | 1990 Buick Century

Not finding what you are looking for?
1990 Buick Century Logo

Related Topics:

212 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...