How do i take the factory deck out of my 96 nissan maxima without braking anything.

for brakes yes for fuel yes

Could be a few things, I would bet you lost the vacuum assist from the master cylinder.

With or without ABS? Or does the master cylinder have two or four lines coming out it? I have a feeling you have a bad masterclinder. The lines on a non abs are cross proportional, meaning one front and one rear are supplied fluid by one part of the master and the other two are supplied by the other. Try cracking the lines loose on the master cylinder and pressing down on the brake pedal. Try this for ll the lines making sure to tighten the fitting before letting up on the pedal ( just like if you where bleeding the brakes at the wheels). If no luid comes out than you just confirmed a bad mastercylinder.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Most likley problem is your brake light switch. go underneath the dash to the brake pedal and depending on wether you have cruise control or not ther will be one or two sensors there. the black sensor should be the brake light switch. disconnect and jump the connector with a paper clip and see if the brake lights comeon and the shifter will move.

You have an oil resevoir for the clutch under the hood near the Brake master cylinder, make sure it is full. these older Maxima will leak clutch oil over time and it needs to be serviced.

my fuse n my 96 nissan maxima keep blowing can u tell me the problem

Your brake light switch is bad. It is located above the brake foot pedal. Have it replaced.

Yes, many aftermarket radio/CD players are made that will fit. Look on WWW.Crutchfield.com

when my 96 nissan maxima gets hot it will cut out and almost like buck like it dose not get enough gas. i have chaged all filters and plugs and coil pack

Hook up the Amp Turn on Wire usually blue/white strip