How do i replace heater core

Basically its in front of your floor shift console. What I did was go to the auto parts store and read the part about replaceing the core. Its not a bad job but I dont have the book and their are a few things to swap it out.
The main thing is when you refill the radiator, make sure you get all the air out before you drive anywhere.

Removal & Installation

1. Disconnect the negative battery cable.
   
2. Drain and recycle the engine coolant.
   
3. Raise and safely support the front of the vehicle.
   
4. If necessary, remove the rear lateral transaxle strut mount.
   
5. Detach the drain tube, then disconnect the heater hoses from the core tubes.
   
6. Carefully lower the vehicle.
   
7. Remove the console if equipped.
   
8. Unfasten and remove the sound insulators, console extensions and/or steering column filler, as required.
   
9. On some models it may be necessary to remove the steering column opening filler.
   
10. Remove the floor or console outlet ductwork and hoses.
    
11. Remove the heater core access cover.
    
12. Unfasten the heater core mounting clamps/bolts, then extract the heater core from the vehicle.
    

To install:

1. Install the heater core, then secure using the clamps/bolts.
   
2. Fasten the heater core cover.
   
3. Connect the outlet hoses and ducts.
   
4. Install the sound insulators, console extensions and/or steering column filler.
   
5. Raise and safely support the vehicle.
   
6. Install the drain tube and connect the heater hoses to the core tubes.
   
7. If removed, install the rear lateral transaxle strut mount, if removed.
   
8. Carefully lower the vehicle.
   
9. Connect the negative battery cable.
   
10. Fill cooling system and check for leaks. Start the engine and allow to come to normal operating temperature. Recheck for leaks and check coolant level. Add if necessary.