I ran out of gas in my Mitsubishi Galant V6 because my guage doesn't read properly. My car sputtered and then cut off. I had my car jumped off. It started but would not stay cranked. This has happened to me once before and a guy told me that there was some kind of button needed to be pressed to reset something. He said it was located on the floorboard or floor wall on the passenger side of the car. He actually pressed the "button" and the car worked fine. Can you tell me what this button is and where it is located?
Anti roll over fuel cutoff... its right where you just said was, take a flashlight on pass side kick panel push button
SOURCE: water pump chang on mitsubishi Galant 2.5 V6
Waterpump replacement requires removal and replacement of your timing belt. Because of this it is not your typical do it yourself repair. Engine timing is critical, and not having your belt set correctly can lead to catastrophic engine damage.
You can purchase a service manual at your local parts store to get an idea of what is involved, however this being an interference engine you should leave this job to a professional if you are uncertain enough about your abilities that you need to ask for help on it. The cost to replace the waterpump is far far less than the cost to repair a engine that had an incorrectly set timing belt.
SOURCE: I can't find spark plugs in the 2003 Mitsubishi Galant V6
YOU WILL HAVE TO REMOVE THE INTAKE.
SOURCE: I have a 2002 Mitsubishi
under the car there is a rubber drain tube you can blow compressed air in it to remove the clog.
257 views
Usually answered in minutes!
×