Unfortunately Ford doesn't supply a download for guides older than 1996.
If the changes were minor (they often are), the '96 version should help:
1996 E350 manual
i was just at the fuel stop to get fuel for the upcomming trip tomorrow and i cant get the fuel to ...
(More)
i was just at the fuel stop to get fuel for the upcomming trip tomorrow and i cant get the fuel to come from one tank or a nother any idea on this
93 wrangler 6cyl, auto when cold backfires, sputters, can barely keep running. Once temp reaches...
(More)
93 wrangler 6cyl, auto when cold backfires, sputters, can barely keep running. Once temp reaches about 180 it runs fine. It happened overnight, drove it all day one day the next morning got up (very cold outside)and it's backfiring, has no power, can't rev/give it gas to keep it running because it just starts backfiring and sputtering. Did complete tune up on it (wires/plugs, dist.cap, rotor, coil), replaced the crank shaft counter sensor (not sure that is the correct name), put gas treatment in thinking it was bad gas but if that's the case I would think it wouldn't straighten out when it warms up. Any suggestions of what else to do or what the problem may be?????
I have a 1992 Ford F 350 with the 5.8 L windsor motor. My check engine light just came on and will...
(More)
I have a 1992 Ford F 350 with the 5.8 L windsor motor. My check engine light just came on and will not go off. If I give it too much gas now, it wants to stall, and it is burning alot more fuel
I startyed my van and before I could fasten my seat belt it stopped running. My son in law tried to...
(More)
I startyed my van and before I could fasten my seat belt it stopped running. My son in law tried to help with a friend of his but the results were ''0'' as fuses and other components were all messed up. They bought a new part but it also did not work. Does anyone have the schematics for this vehicle ignition?
Good morning, my name is David & I have a workshop in Adelaide South Australia. I have been...
(More)
Good morning, my name is David & I have a workshop in Adelaide South Australia. I have been asked to repair a Taylor Dunn vehicle model B2-10 serial No. 76778. The fault is when I try to move the vehicle forward or back the solinoid just hammers (clicks)then nothing. I have checked battery voltage (overall 37.6v) with a meter & hydrometer & they are o/k. I fitted new solinoids but the fault is still there. Can you help or can you supply a workshop manual ???....David Your system will not let me put in the correct vehicle!!!