1998 chevy z71 4x4 automatic can i change out a 5.0 vortec for a 350 non computer controled engine with a carborator on it wat does the computer run on the truck
Comments:
Nov 05, 2009
- the engine in the truck is shot not even rebuildable i have a 350 that i had rebuilt for my 83 chevy that has only 20,000 miles on it and a 7004r 4x4 trany to get a rebuilt 5.0/305 is $1,900 to $2,400 that i dont have laying around if you know what i mean i did find a 5.3 out of a 99 with the computer and wiring for it for $400 but was told that i would have to change the whole wire system for the truck is that true?
Nov 05, 2009
- can i take the 5.0 heads and intake and timming cover and put them on a 350 non vortec and have it work?i know that you can do that with the older 305 and the 350 every thing would line up and bolt on small block to small block
The computer runs the Transmission from the signals the throttle position sensor, crank shaft sensor, and cam shaft sensor. Your going to have to replace the transmission with an older transmission like the turbo 350 or turbo 400. When it's time to get the car e-tested, that's when your going to run in to problems, due to the year your Chevy is. If your Chevy was a 1985 then you could go with the carb system but with being the newer OBD11 system, your going to have an off road only vehicle with that swap. Why would you want to replace the engine with the 350 carb set up??? There are things you can do to tweak the one in your Chevy free of charge.
Transmission shifting hard between 1 and second. Had a 600 pound quad runner in back. Quad runner...
(More)
Transmission shifting hard between 1 and second. Had a 600 pound quad runner in back. Quad runner totally over secured could not move at all. Problem disappered after removing load.At first I though it was the load shifting so I stopped and checked. No slipping and smooth operation during the rest of shifting. The truck has 159,000 miles. 4 wheel drive. Well maintained.
I cannot seem to find the esc wire connector for my 98 chevy truck.....I can see the wire behind the...
(More)
I cannot seem to find the esc wire connector for my 98 chevy truck.....I can see the wire behind the glove box when I take it out, but there is no connector...... 4.3 vortec...
How do i install a hiniker plow frame on my 1998 silverado 1500? Where can I get the instruction and...
(More)
How do i install a hiniker plow frame on my 1998 silverado 1500? Where can I get the instruction and wiring diagram for installing my hiniker plow on my truck?