SOURCE: driver side power window keeps coming off track
u are going to have to remove the window and the rail it sets and have a glass shop reset it with a special tape.
SOURCE: DRIVER SIDE WINDOW OFF TRACK
you must pull door panel off (you can find the tool at any parts deals) then lift the window up with hands only it is hard but can be done get some one to hold the window glass up and check to see if any parts have fall if so put back on or replace. if not missing clean track and crank up to glass and line up. wind up and down to make sure it stay and then re-place door panel. hope this works it did for me on my 95 contour
alienphone
SOURCE: 94 continental power window problem
you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to pull off the seal in order to see inside the door. There should be two bolts holding down the inside guide rail and two bolts holding down the outside guide rail
SOURCE: Drivers side window has slipped off track 2006 mazda mpv
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.
SOURCE: my driver side window has come off its track on a
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you'll be able to get to the tracks. You may need to get some replacement clips to remount the window to the track
Testimonial: "Thank you for your quick response this was great information for fixing the window"
248 views
Usually answered in minutes!
×