I have a Murray Rider Mower with a Briggs & Stratton Engine Model number 287707. The Electric Starter gear turns, is not worn, but will not rise and meet the engine gear to turn the engine.
Is this a bad starter in that the Electric Starter gear will not rise and meet the engine gear.....or does the battery not have enough starting amps to raise the turning gear to meet the engine gear.
try some wd40 on the shaft the gear rides on. work the gear by hand alittle it may just be stuck. usually if you dont have the power to spin the gear up the starter wont run at all
i hit a median very hard then next morning it would only crank but not start. i did get it started 4...
(More)
i hit a median very hard then next morning it would only crank but not start. i did get it started 4 a few seconds by pumping the gas but it was backfiring and i just shut it off now it dont start at all. when i turn key no noise at all did a wire come loose on the starter?
traction control kicks on when starting up engine. Cannot turn off with switch, must drive short...
(More)
traction control kicks on when starting up engine. Cannot turn off with switch, must drive short distance and then turn off/on engine again. This usually kicks it off until next time. 2000 Q45 with 87k miles. Any thoughts?
what problems could i get with 79k jaguar s-type 4.0l im trying to buy this car but i doknow if this...
(More)
what problems could i get with 79k jaguar s-type 4.0l im trying to buy this car but i doknow if this car is conplicated an any way.
we change the cambelt and something very wrong happened, after putting everything together and...
(More)
we change the cambelt and something very wrong happened, after putting everything together and starting the car.. it sound really wierd and the car is shaking. Probably the geerwheels are in wrong positions even though we align all the marks. How do we set the engine back to zero?? how do we see which one of the wheels are in the wrong position??or if any of the valves are broken?