Take out the drive-axle. Cut the old rubber-boot clamps off and discard them.
Remove the boot from the inner CV joint nnd slide the tripod from the joint housing.
Remove the snap-ring with a pair of snap-ring pliers.
Drive the tripod the tripod joint from the drive-axle with a brass punch and hammer; careful not to damage the bearing surfaces or splines on the shaft.
command start is causing lights/locks to swwitch on/off. where is the controll module located for...
(More)
command start is causing lights/locks to swwitch on/off. where is the controll module located for the ultra command start 2004 toyota camry, so i can discinnect it?