check engine light and reduced power light are on at the same time. power is greatly reduced. what could be the problem? 2001 isuzu trooper. need help, please.
Pluged E G R valve and confused E C M as a result is likely...Pull vacuum hose off at E G R valve (engine cold please) If metal tube pluged up clean out with 1/8" drill bit.Vacuum test with hand pump (should hold pressure when pumped up and relieve as you you relieve tool valve) if available if not try it out on the road after reaming.
I changed the EGR VALVE AND WHEN I STOP FOR RED LIGTH OR STOP SIGHT MY CAR SHUT OFF BY ITSELF AND...
(More)
I changed the EGR VALVE AND WHEN I STOP FOR RED LIGTH OR STOP SIGHT MY CAR SHUT OFF BY ITSELF AND SHAKE A LITTLE BIT. I ALSO CHANGED THE SPARK PLUGS AND STILL THE SAME PROBLEM.. PLEASE ANY INPUT FOR HELP..
when on motion after about few kilometer the movement of d vehicle is not smooth then when the gear...
(More)
when on motion after about few kilometer the movement of d vehicle is not smooth then when the gear change it usually make a solid noise as if two iron hit each other.Also want to know the appriopriate place to change the automatic gear oil. In the derch board where u have the all the mitters, there is a place written FUEL DOOR pls what is the meanning. I also notice the vehicle consume excess fuel And the expert here could not solve the problem. Can i also get the mannual
Hi, I had a similar problem and ended up having to rebuild. I changed the fluid first (which is a...
(More)
Hi, I had a similar problem and ended up having to rebuild. I changed the fluid first (which is a true chore) and after that the hesitation was still there, when I had the trans pressures checked the flares were in the low/reverse and the 2nd gear mostly with a small flare beginning in third. I recommend having it pressure checked to see what the problem really is. Some shops do that for free. Hope this helps.
the reason i ask because i have seen the solenoids and the valve body but didn't want to pull down...
(More)
the reason i ask because i have seen the solenoids and the valve body but didn't want to pull down if i was going to mess up something else by doing so.