Ford f150 xlt 4x wont engage

What vehicles interchange with F150 4.6? - Ford F150 Forum ...

www.fordf150.net > ... > Modular/Triton V8 Engines: 4.6L, 5.4L (97-10)

Feb 17, 2007 - Well I have a 2000 F150 XLT 4.6 V8 and need a motor, What other vehicles have the same 4.6 V8 that will interchange with this truck? ... possibly an expedition of the same model year, I believe they have a 4.6 or 5.4. ... X - 4.6L EFI-SOHC, eight cylinder (Engine used only for Mustang GT and differs from ... Can i swap my 4.6L for a mustang 5.0 in my 97 f150? - Ford F150 ...
Apr 13, 2011
4.6 to 5.4 engine swap, help!! - Ford F150 Forum - FordF150.net
Jan 18, 2009
Will an intake manifold from a 5.4 fit on a 4.6? - Ford F150 Forum ...
Jan 26, 2004
More results from www.fordf150.net

4.6 to 5.4 Swap Notes - F150online Forums

www.f150online.com/forums/articles.../355403-4-6-5-4-swap-notes.html

Dec 7, 2008 - Application: These notes cover the F-150 from 1997 to 2004 Heritage ...All 97-00 and some 2001 4.6 engines use some sort of intake manifold .... So a 1999+5.4 PCM in a 1997-98 truck will need to have its PATS disabled. 5.0 coyote swap in 97-03 f150?
Nov 12, 2011
4.6L engine swap
Jun 12, 2010
4.2l to larger - motor swap?
May 1, 2009
6.8 V10 Engine Swap
Jan 22, 2003
More results from www.f150online.com

Do you have 2 gas tanks?

I would pull the transfer case
Strip it & replace what is needed
& go from there, after reinstall

I would never install a used part
until it stripped it.

AOD
http://racetransmissions.com/mainpages/tech_info/trans-vehicle-finder/domestic-trans-list.html

here is a link to help

The New Body Style 5.4 does not have an IAC, this is controlled by the throttle position motor on the side of the throttle body, and is operated by the PCM ( new body style is throttle by wire ).

If this is a 2004 Heritage or lightning ( the same body style as the 97-03 MY ) the IAC is on the back the throttle body, held on with 2 8mm screws. You would need to remove the plastic throttle body cover to get to it.

Hello! I would suspect the Four-Wheel Drive Switch is defective...If you have a multimeter and a wee bit of experience using it the switch can be tested before buying a replacement...If you do not have a meter and are uncomfortable performing a test just let me know...

Pop the switch out...It has a four pin connector...Wire colors are...pin 1=Black...pin 2=Dark Blue...
pin 3=Dark Blue...pin 4=Light Blue/Red...We are interested in pins 2 and 3...Set the meter to the X10 ohm scale...Disconnect connector...Read across pins 2 and 3...Record reading on each of the three positions...Send a comment with results...Guru...............saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

rear end axls is freeze

check the starter. the battery. or the colenoid switch.

I copied something that you might use because it was handy I know its not going to be exactly for you but it might get you fixed. Let me know if it helps or NOT please. gl dc

did you lock your hubs or are they auto?