Remove the serpentine drive belt, as outlined in
of this repair guide.
Disconnect the A/C compressor upper support brace, then lay the compressor in the fan opening.
Raise and safely support the vehicle.
Detach the engine oil cooler lines at the flex connector.
Unfasten the retaining bolts, then remove the flywheel inspection cover.
Remove the starter motor retaining bolts, carefully lower the starter and remove the shims, if used.
Detach the starter motor wiring, then remove the starter from the vehicle.
Fig. Fig. 12: Starter motor removal and installation-1992 3.8L engine shown To install:
Attach the electrical connectors to the starter terminals.
Tighten the battery terminal nut to 80 inch lbs. (9 Nm) for 1991
vehicles and to 12 ft. lbs. (16 Nm) for 1992 vehicles. Tighten the "S''
terminal nut to 27-35 inch lbs. (3-4 Nm).
Position the starter motor and shims, if used, to the engine and tighten the mounting bolts to 32 ft. lbs. (43 Nm).
Install the flywheel inspection cover. Tighten the retaining bolts to 89 inch lbs. (10 Nm).
Attach the engine oil cooler lines at the flex connector.
Carefully lower the vehicle and position the A/C compressor.
Install the A/C compressor upper support brace.
Install the serpentine drive belt, as outlined in
of this repair guide.
Install the right side cooling fan
Connect the negative battery cable.
Fore other engine and sub-models, review autozone.com (free register).
i need the power window drivers side switch I found one for a 96 lumina and i have a 98 will the 96...
(More)
i need the power window drivers side switch I found one for a 96 lumina and i have a 98 will the 96 switch work in the 98
i have a 1992 chevy lumina it has the 3.4 and i just put in new fuel pump and new spark plugs and...
(More)
i have a 1992 chevy lumina it has the 3.4 and i just put in new fuel pump and new spark plugs and wires and it ran for about a half hour just fine i took it apart and i have gas going to fuel rail but it will not start is it possible that the crank sensor just went out i drove it for about 20 feet and just died and will not start just rolls over it will run for a bit when i shoot thrust into the throttle body ? possibly a sensor of some sort or mabey fuel injectors