Location off the blower resistor. - Safari GMC Cars & Trucks

Blower Motor Resistor

Blazer Forum https://blazerforum.com > forum > blower-motor-resis...
Oct 20, 2010 - The blower motor resistor is located under the hood on top of the HVAC housing towards the center of the truck. Run a search on "blower+motor+ ...

Can't locate Blower Motor Resistor on 1998 Blazer 4x4
Jan 11, 2012
2000 Chevy blazer blower motor won't work on high!
Aug 19, 2023
New blower motor,new resistor, no power - Blazer Forum
Aug 9, 2020
2000 Blazer - Heater blower Not Turning On
Oct 25, 2013
More results from blazerforum.com
https://www.google.com/search?q=2000+Chevy+Blazer+2WD+4.3+V6.+Blower+motor+resistor

The blower resistor in a Toyota Townace Noah with a 3S engine is typically located near the blower motor, which is responsible for directing air into the vehicle's cabin.
Here is a general guide on how to locate the blower resistor in a Toyota Townace Noah with a 3S engine:

1. Locate the blower motor: The blower motor is typically located under the passenger side dashboard, near the footwell.
2. Identify the blower resistor: The blower resistor is typically a small rectangular or cylindrical component that is connected to the wiring harness near the blower motor.
3. Remove the blower resistor: To access the blower resistor, you may need to remove the cover or the panel that covers the blower motor. You can then unplug the wiring harness and remove the mounting bolts to remove the blower resistor.

Note: The location and accessibility of the blower resistor may vary depending on the specific model and year of your Toyota Townace Noah with a 3S engine. If you are unsure about the location or how to access the blower resistor, it is recommended to consult a professional mechanic or the vehicle's owner's manual.
It is important to handle the blower resistor with care, as it can be easily damaged if not handled properly. If you are not confident in your ability to replace the blower resistor, it is best to seek assistance from a qualified mechanic.

up under dash pass side in blower housing

Before removing the heater switch on this 2006 citroen hdi I would first have the blower motor checked and the most common reason for this and other blower problems would be the blower resistor.

Your blower works on and off at times, first locate the blower motor and the resistor. the blower motor is located on the heater box, look under the pass/side of the dash, you may have to remove under dash cover to see blower.
When you have located the blower now look to the side on the heater box, there you will see a connector plug, it plugs into a connection on the heater box, this will be the resistor, the resistor slides into heater box and the end of it bolts to box to hold it in place and then the connector plugs into it, if you can not locate it then follow wires that plug into blower , follow wires back they will lead you to resistor,
next time blower does not work wiggle connector to resistor and see if blower turns on, if it does then resistor is the problem. also unplug resistor plug at resistor and check for any burning of connectors at plug and inside resistor.

I would bet its a bad resistor or the plug is brunt due to high draw from bad connections, if plug has burn damage to connectors then replace the plug along with resistor.

BLOWER MOTOR RESISTOR IS UNDER THE HOOD IN THE ENGINE COMPARTMENT LOCATED ON THE BLOWER EVAPORATOR HOUSING ON THE SIDE TOWARD THE ENGINE RESISTOR IS LOCATED NEXT TO THE BLOWER AIR CONDITIONING RELAYS.

The resistor is located under the hood on the passenger side. At the back of the engine compartment you need to locate the airbox it can be identified by a circular piece that's right beside the fender on the firewall (this is your blower motor) to the right if it (looking from the front of the truck) about 4 -6" you will see a wire plug. Unplug this connector and locate the four screws that attach it to the air box. Remove these screws and pull the resistor from the housing.

Hope helps (remember to rate this answer).

If the blower moter only works on hi speed it is the blower motor resistor that is bad. The blower motor resistor is located under the passenger side of the dash next to the blower motor. It is not necessary to remove the blower motor to change the resistor.

SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal

1. Remove the upper footwell trim panel (passenger side).
   • Remove the pushpins.

1. Disconnect the blower motor resistor electrical connector.

1. Remove the blower motor resistor.

-------------------------------------------------------------------------

if you locate the blower motor the rester is the wire that atachec to blower motor fallow wire till you find a circuit bord this is ur resistor