After driving about 3 hours just start stuttering and stopped then the engine stopped, check engine and check transmission light came on, had someone bring me some gas and everything worked fine after that

If you are talking about a missfire, you should have a check engine light and trouble codes stored in the engine computer.

It sounds to me like a passing gear issue. Or even and Over Drive issue. Try this to find out. When you put the car in gear, instead of O/D, try regular drive. If you have a push button O/D then deactivate it. If you only have Drive, then try shifting into 3. Run the car up to the same speeds you were having problems with. If you don't have the issues with the higher RPM's then it is an Overdrive/Highway gear issue. If it still stutters, then it could be a fuel delivery issue. Good luck.

Could be a transmission problem or something as simple as bad spark plugs.
The engine is under the most load when RPM is low and you are trying to accelerate, such as when it upshifts.
You should have the computer checked for trouble codes and hopefully that will point you in the right direction to test.
If the spark plugs have more than 50,000 miles of wear you might start with replacing them.

Hello
The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

You'll need to have someone scan the computer for the codes.
Most auto parts stores will scan for free in hopes of selling you some parts. Once you get the codes you can research them online or in this question.

Your confusing MAP with a MAF sensor . You can not clean a MAP sensor .
manifold absolute pressure sensor (MAP sensor )
mass air flow sensor MAF you can clean .

admissions = emissions !
accelerate again and it starts to stutter. Try the TPS - throttle position sensor .

these are diagnostic charts that the dealer used back then hope it helps

This is what you need to do, change the plug wires, because if there is a bad wire you would definitely experiences sputter or a stutter, so do the plug wires and at the same time do the spark plugs, this should take care of your problem. if not let me know and i will give you the next step

Computer firmware needs upgrade

Take your car to a Chrysler dealer shop and have them update the transmission program.As your tranny wears it loses it shift point and stutters between 40 - 45 mph looking for the right gear to change to..Had same problem in 94 Concorde and 94 T&C minivan.Reprogramming tranny fixed both cars.

chances are fairly good it's the coils - I've posted about this on Edmunds. the OEM design is truely idiotic & has a vent that allows moisture down into the plug well - that shorts the spark & causes misfires. On our 2004 MPV I got away w/cleaning & drying them extremely carefully then sealing the vent w/silicone as a temp measure, then ordered perfect replacement after-market coils off ebay that sealed the wells & stopped the problem -and- were a tiny fraction of the OEM price.  good luck, BK