The headlight unit is held in place by a lever located behind each
unit in the engine compartment. Some earlier units also had a locking
clip. Moving the lever down releases the complete unit that can then be
withdrawn out the front of the fender. Note: Road grit and general
accumulations of dirt may make this less than smooth. After removing
the whole unit the headlamp bulb is accessible by removing the cover
at the rear of the unit and removing the bulb. Replace with new halogen bulb - do not touch the glass with bare hands as the
oils on your fingers will cause hot spots and cause the bulb to fail. Replacement is the opposite
of removal although you may want to clean out the fender opening before
replacing the light unit. Lock in place using the locking lever.
Hi. I have a 200 VW Bora V5. The oil quantity indicator light came on while driving. I stopped and...
(More)
Hi. I have a 200 VW Bora V5. The oil quantity indicator light came on while driving. I stopped and checked the oil level...it was fine. I took the car to the service location and they did a complete service (to include oil change) but the light was still on. So I drained the oil, replaced the oil sensor, and refilled it...but the light is still on. It is not the red "oil pressure" light, it is the yellow "low oil" light...any ideas?
the back drivers side window on the convertible beetle wont go up and seems to be off the runners!...
(More)
the back drivers side window on the convertible beetle wont go up and seems to be off the runners! how do i fix this?
want to change head light low beam bulb. how do i get to it on driver side and how do i get the bulb...
(More)
want to change head light low beam bulb. how do i get to it on driver side and how do i get the bulb out