Every time i unlock my hyundai coupe it relocks its self its a 2004 v6 model

The easy way is to go to the dealership parts department. They would keep those in stock. Or you go to a spares motor factor like the ones below. They are picking up 'wheel bearings', but they can supply all bearing parts..

Wheel bearing for HYUNDAI Coupe II (GK) - Buycarparts.co.uk

https://www.buycarparts.co.uk > ... > COUPE (GK)
Hub bearing for HYUNDAI Coupe II (GK) Petrol / 1.6 - 2.7 liters / 2001 - 2009 MY ... G4GC 02/2003 - 08/2009; 2.7 V6 (121 kW / 165 hp) G6BA 01/2001 - 08/2009 ...
Missing: manual ‎' Must include: manual

• 
  

  Wheel bearing for HYUNDAI COUPE - Buycarparts.co.uk

  https://www.buycarparts.co.uk > ... > COUPE
  Couldn't find your car in the catalogue? or. Enter your registration below. GB. Search ...

Wheel bearing for Hyundai Coupe gk - AUTODOC

https://www.autodoc.co.uk > ... > HYUNDAI > COUPE
Wheel bearing rear and front for HYUNDAI COUPE (GK) from 2001 MY from various OEM part manufacturers. Huge brand selection at low prices ? Hub bearing for ...
Missing: litre ‎output

• 
  

  Car parts & accessories for HYUNDAI COUPE - AUTODOC

  https://www.autodoc.co.uk > spares > hyundai > coupe
  Over 5000 car parts for HYUNDAI COUPE found in stock at AUTODOC ? Purchase vehicle parts ? auto accessories for HYUNDAI COUPE online at affordable prices ...

Transmission output shaft bearing. - Hyundai - JustAnswer

https://www.justanswer.com > hyundai > 94h1d-transmi...
Jun. 3, 2015 - Transmission output shaft bearing. problem. Our 2005 Hyundai Accent stick shift. Parts errand car. Replaced CV - Answered by a verified ...
1 answer · Top answer: See the answer on the image
Missing: reg ‎' Must include: reg

the length of time that a car says unlocked is dependent on the make
most are around 30 seconds before it relocks itself
to stop it relocking just open a door and then close it and it stays unlocke d

had a similar problem with a hyundai coupe , this turned out to to be the door lock mechanism in the drivers door, so could be the place to start, as i would have thought that generally the power locking technology is the same universally

the manual you seek is HAYNES also called Hundai coupe for the rest of the world.

For the 2004 Hyundai Santa Fe:
I do not know if you have the 2.4L DOHC In-Line 4-Cylinder, 2.7L DOHC V6, or the 3.5L DOHC V6 Engine; however the Link below has all three Diagrams.

Click on the following: direct, free Link. It has the Belt Diagrams for your 2004 Hyundai Santa Fe. It also has very helpful Instructions and Directional Diagrams.

Let me know if this helped...
http://www.2carpros.com/car_repair_information/year/2004/make/hyundai/model/santa_fe/2004_hyundai_santa_fe_drive_belt_routing_diagram.htm

try ebay .com

the batteries may be in need of replacement or wires are rubbing causing it to work itself ..tilt wheel and or from opening and the closing of the door causes wires to break and make a connection allowing it to operate itself remove the door panel and visually inspect the wiring

usualy tis is caused by the door key cylender sensor switch beeing loose or damage espacilly if you have had a slim or a wire hanger in the door panel trying to unlock the doors if this is the problem it will also over time run your battery down its kinda like your holding the lock button down all the time

It sounds as if there is a blockage either in the base of the screenwash reservoir or the feed pipe from the reservoir. You could remove the screenwash reservoir tank and clean it out and at the same time check the pipe.

Please remember to rate this solution.

had very similar problems with a Hyundai coupe , turned out to be the central locking control mechanism , this is usually the drivers door lock unit inside drivers door , this controls the locking system and so also interior lights as if having used remote etc,hope this helps