Wont start. Starter does not turn. - 2005 Jeep Wrangler

It is probably turning off, but it is sticking out. It is not retracting back from the flywheel so the engine is still turning it. You may be able to fix the starter, with a rebuild on the gear or just get a new starter.

Dead Battery
Bad Starter Solenoid
Bad Starter

The starter solenoid clicks, your past the
security system & starter relay

Battery voltage is definitely and issue. Charge your battery and have it tested before condemning the starter.

Replace the starter, the solenoid cant engage the starter because it is locked up, hence the extreme voltage drop with the fan when you try to start it with the fan on.

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks

That sounds like a starter issue. If the engine is clicking when you turn the key on it will be starter. If there is nothing when your turning key on it's probably battery or solenoid issue. Solenoid for starter is located attached to the side of your starter.

That might be a possibility. Asssuming when you say it wont start you mean it won't crank over. First check battery voltage at the battery with a dvm when you turn the key to the start position. Then check the voltage at the starter when you turn the key to the start position. If both readings are the same and you must have a reading of at least 12dcv. Try turning the ignition key to the on position( not the start) and jump the positive voltage from the starter to the solenoid terminal. The starter should crank over if the proper voltage is present.If the starter just clicks or just attemps to start. yes, you need to replace your starter

bad starter or starter connection , check connection on starter

starter

Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me
[email protected]<<<<<<<<<<<<<<<