My 2001 grand prix wipers still work but are stuck in up position.. any suggestions?

Fuse, switch, wiring, bad motor.

u need a new parkpawl witch is mounted on the wiper motor. wiper linkage connects to it.

Wiper delay module is stuck, tap on wiper motor. If it don't quit you'll have to replace it.

You wont need to, all you need to do is un screw the nut that holds the wiper blades, adjust to the desired position and re tighten. Easy Fix

no need to get to the motor, you need to loosen the bolt that holds the wiper, make sure the wiper is set to off after you loosen the bolts ajust to the desired place and re tighten the bolts that will deffinitaly fix your problem, it fixed mine anyway.

needs wiper module. check bushings around wiper motor at the firewall.

While the wipers are in the parked state, just loosen off (or remove) the wiper arm from the drive spigot and re-position the driverside wiper arm to the correct position.
Re-tighten arm drive mount and all should be well.

You have a bad Park switch. Its located on the wiper motor. Replacing the wiper motor should solve the problem.

at the edge of arms pull cap off after that loosen the bolt put the wiper wher e it should be then bolt it back up tight then put cap on / Then try it/ Please rate my response thank you very much

You have two problems. The first is the wipers turn off and stay in the upright position and do not close. The motor is fine. There is a steal 'close' tab that has been bent out of position. You just need to push the steal tab back into position. You can use a chisel or screwdriver to pound it back into the 90 degree position.

The windsheild washer motor probably needs to be replaced