Question about 1999 Nissan Frontier

Open Question

1997 Nissan Pick up speedometer stopped working immediately after a repair shop repaired the emergency brake cable. What can I do next since the code readout stated that that it might be the sensor? The truck has under 30,000 miles. If I need a new sensor, where is the cheapest place to purchase this sensor since it retails for $178? Thanks, Ted

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: 1997 nissan pickup xe headliner

arreglar el motor ... como hago

Posted on Jul 08, 2008

jschoon77
  • 55 Answers

SOURCE: Odometer Repair on a 1996 Nissan Pick-up XE

The teeth on the ODO gear are most likely stripped. Seen this a hundred times. Dealer- only repair unless you buy a used speedo head.

Nissan Scope Technician- 10 years with Nissan

Posted on Oct 29, 2008

pal03246
  • 705 Answers

SOURCE: brake light on nissan maxima 1997

First check your brake fluid. It may be low. If its low, have your brakes checked, they may be worn out and you may need brakes. If the master cylinder is tottaly empty, than you may have a leak. Here is a quick test for the E-brake switch. Look at the "brake light" while its on and pul on the e-brake while you are holding the release button in the handle. Pump the e-brake lever repeadetly and observe the "brake light" if it gets brighter and dimmes as you are pumping the e-brake lever., than the swithc is OK and you have a low brake fluid level. Hope this helps. let me know what you find.

Posted on Dec 12, 2008

stevehinrich
  • 61 Answers

SOURCE: 1997 maxima emission code repair on 400 & 500

P0400 is auxillary emmisions control and P0500 is vehicle speed idle speed control auxiliary inputs.

Posted on Mar 02, 2009

  • 8 Answers

SOURCE: 1997 Nissan 200sx Speedometer not working

dash boar is electric. the fuses for that are on almost under the dashboard. like in fron of the drivers left leg there is a cover you have to pull off. but you may need to replace the cluster.

Posted on Jun 10, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The emergency brake on a 1997 Chevy Malibu was engaged in very cold weather and has a loud soundevery time regular brake is used. What can be causing this and how to repair?


Could of worn down the back secondary brake shoes,you will need to remove both back hubs to exam.The emergency brake cables are attached the the back brakes on the rear,there's a hole in plate where cable goes thru and attaches to brake shoe.Do you need step by step on how to check and remove hub?

Nov 25, 2012 | 1997 Chevrolet Malibu

2 Answers

The emergency brake on my 1997 jeep wrangler appears to be hung up. Do I need to bring the jeep to a shop for repair or can I work on it myself?


You can order the part and save some labor but not much. It only takes 30 minutes to take off the cable from underneath the chassis. You can get step by step instructions from autozone.com by registering fro free and then register your jeep...all for free. Thanks for using FixYa. By the way I dad the same problem on my 4x4 Ranger.

May 26, 2011 | 1997 Jeep Wrangler

2 Answers

The Abs lights in the Nissan Wingroad is on, how to turn it off? also the speedo metre is not working. will it be related?


you need to have faults read. you need a scanner to read codes and any good parts store or shop can scan and tell you what needs to be repaired or what triggered fault. Once fault is fixed they cabn reset lights for you.

Jan 07, 2011 | 2006 Nissan Z

1 Answer

Control ?i have a 1997 s10 pick signal flashers ( right and left ) stopped working, fuse replaced no go, all other electrical working ( brakes /emergency flashers etc) what do you suggest mission


The flasher may have gone bad for the turn signal, and there may be a second flasher for the emergency flasher lights. Look and listen for a click of the flasher for the emergency flasher lights. Then, the other flasher is the one to replace.

Good luck on this repair.

Dec 18, 2010 | Chevrolet S 10 Cars & Trucks

1 Answer

My brake light and battery light stays on when driving. Also emergency brake does not work.


OK, the brake light is caused most likely by the emergency brake cable being broken, and the pedal or brake lever is not in position.

Also, the brake light could be caused by low brake fluid level. Check that, too.

Battery light, is caused by the charging system not working, like a bad alternator or shorted out battery, or both.

I would have these issues repaired before driving any distance.

Jul 08, 2010 | 1997 Nissan Sentra

1 Answer

2006 ford explorer. While driving and abs code, a picture of a wrench and the truck skidding picture came up. What do codes mean besides taking it in immediately!!!!? How much will this cost to repair or...


Sounds like your car is reporting a fault with the anti lock braking system. Sometimes this can be caused by a faulty sensor. Whilst the car still has brakes it could be that their anti -lock function is no longer working and this would compromise your brakes at the limit in an accident situation. To test, and in the process perhaps allow the sensor to reset, find a quiet stretch of road free of other road users, especially users behind you. Do an emergency stop from about 40mph by just stamping on the brakes as hard as you can. If the ABS is still working you will feel back through the foot pedal a shuddering sensation. If there is no shuddering and the wheels lock out and car skids to a stop then your abs unit and braking system need a look at. Check your brake fluid level and check your ABS sensors and cables for integrity. If everything looks OK but the fault still remains then take it to the shop for a complete diagnostic study.

May 24, 2010 | 2006 Ford Explorer

1 Answer

Speedometer quit


The speed control sensor is disconnected it is located on the transmission. I think someone did not connect a harness or it came loose or it is damaged

Mar 23, 2010 | 1991 Nissan 300ZX

1 Answer

1997 Nissan XE Pick-up A/C Issues


have the ac clutch checked

Jun 22, 2009 | 1997 Nissan Pickup

3 Answers

Emergency brake repair


sounds like you need an emergency brake adjustment. Around 35 dollars. I'm sure while it's being adjusted the brtakes will also be inspected. Rear brakes might also be low.

Mar 31, 2009 | 1992 Nissan NX

Not finding what you are looking for?
1999 Nissan Frontier Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...