Question about 2002 Dodge Stratus
You need to remove the screws and pushpins on the bumper cover on the side where the headlight is to be changed. then there are two small bolts, one long and one short to be removed from the top of the headlight. then just unplug the wires. this is for a sedan
Posted on Nov 28, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
a battery should cost around $50 for a good one bumper not painted $120 and each headlamp $160 figure in $120 in paint and supplies and reasonable labor or $250 depending where your at it could be as high as $900. and no other damage to mounting would cause the price to be higher. dont expect a perfosional body shop to cut corners they wont they have to fix it right.
Posted on Aug 23, 2008
If it's a chrysler engine the thermostat is located just below radiator cap. If mitsubishi diamond star engine it's located on the cylinder head , beside the air cleaner housing
Posted on May 10, 2009
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
Posted on Oct 18, 2009
jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you
Posted on Apr 13, 2010
Tips for a great answer:
Dec 25, 2012 | 2005 Dodge Stratus
Aug 17, 2011 | 2002 Dodge Stratus
Mar 29, 2011 | 2006 Dodge Stratus
Jan 23, 2011 | 2002 Dodge Stratus
Dec 22, 2010 | 2005 Dodge Stratus
Nov 08, 2010 | 2005 Dodge Stratus
Apr 09, 2010 | 2005 Dodge Stratus
Apr 04, 2009 | 2002 Dodge Stratus
1,105 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: