Question about 1994 Jeep Grand Cherokee

1 Answer

Jeep cherokee tensioner where is it located 1994

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,187 Answers

It is the "center" pulley. It is attached to the engine block with an "arm" that is spring-loaded. The center of the tensioner has a 1/2" slot for using a 1/2" socket wrench or handle to ease the tension.

Posted on Oct 08, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6982 Answers

SOURCE: im trying to locate the starter for 1994 jeep grand cherokee , see if its easy to replace, and also the location of the starter relay

starter relay is in power distribution center near battery. don't know which engine you have, but if you flollow the positive cable on the battery, it will lead you to the starter. Most are not difficult to replace, depends on how much experience you have. One tip...dont overtighten wire connections on starter the solenoid cover is plastic and can break.

Posted on May 07, 2009

motor1258
  • 6674 Answers

SOURCE: can't release tension on serpentine belt

You might find tension is adjusted at your power steering pump for that engine & belt.

Posted on Jun 02, 2009

  • 1 Answer

SOURCE: 1994 Grand Cherokee Jeep wont start

It is likely one of your battery cables loose. Same thing just happened to me today. What you need to do is first lock the doors, and close them. Then you need to disconnect, and reconnect the battery cable, then if the security lights still blink you must use your key to unlock the door, then it should stop blinking, and start just fine.

Posted on Jun 02, 2009

techbuster
  • 5081 Answers

SOURCE: 1994 jeep cherokee workshop manual free download required

onlinefreeebooks.net/automotive-machinery-power-equipment-ebooks/chrysler/1993-chrysler-zj-jeep-grand-cherokee-grand-wagoneer-service-manual-and-supplements-pdf.html
just go the above link i think u can get one online for free please rate my answer

Posted on Jul 03, 2009

  • 306 Answers

SOURCE: speakers for 1994 jeep grand cherokee

6.5" in all the doors dash is wierd. 2.75" but i have been able to squeez in a 3.5"

Posted on Feb 04, 2010

Testimonial: "thank you so much, that helps me out as lot"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Removal of serpentine belt on 1994 Jeep Grand Cherokee


Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

Jan 27, 2012 | 1994 Jeep Grand Cherokee

1 Answer

Which pulley is the tensioning pulley on a 1994 jeep Cherokee


If you're referring to the 4.0 I-6, there is an idler pulley located directly under the air conditioning compressor pulley.

However, tension is adjusted through the power steering pump. You will have to loosen the two bolts behind the power steering pump, two or three bolts which attach to the power steering bracket, as well as the one under the front of the pulley.

There is also another bolt under the driver's side of the power steering pump. This one actually controls the belt tension

Read more: http://wiki.answers.com/Q/Where_is_the_tension_pulley_on_a_1993_jeep_Cherokee#ixzz1G1MayEF3

Mar 08, 2011 | 1994 Jeep Cherokee Country

1 Answer

Hello, how to relieve the belt tension on jeep grand cherokee 1995?


Hi,


In order to relieve the belt tension in your cherokee jeep,you have to locate the belt tensioner pulley first, which is found between the crankshaft and a component toward the top of the hood area.

Afterwards,Rotate the belt tensioner pulley, using a wrench spanner to relieve the tension on the belt.



Good luck.

Aug 20, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Where is the horn located?


drivers side inter fender well closed to the front bumper

May 09, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Need serpentine belt diagram for 1994 Jeep grand cherokee v8. 5.2 liter. Don't have acess to vehicle to go to store or library.


Starting at a/c compressor working clockwise: Over a/c, over p/s pump, backside of belt over water pump,, down around crank pulley, up over idler/tensioner, over alt, under idler and back to a/c.

Feb 12, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Serpentine belt tensioner


if you have 4l inline6, there is no tensioner on it. you adjust the belt via alternator. On the V8, you'll find him on the pass. side in front of the cyl. head.

Dec 12, 2009 | 1994 Jeep Grand Cherokee

2 Answers

I need to replace my serpentine belt. Which


For a 94 Jeep grand cherokee, the tension is controlled through a long bolt on the power steering bracket. The bolt is about 6 inches long, located underneath the power steering on the driver side. Lossen the lockbolt holding it in place, as well as the Power steering attach bolts, and turn the long bolt to tighten/loosen. I believe these are all 13 mm bolts.

Jun 30, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Driver Side Door for a 1994 Jeep Grand Cherokee.


Bad news...you have just sent your phone # around the world!!! Good news is there should be lots of doors in local scrapyards...most larger yards also work online and can locate one.

May 27, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Adjust wiper arm tension on 94 Jeep Grand Cherokee


there is no tension adjustment if the arm is too loose and dosen't put enough pressure on the windshield you need to replace the arm you can bend the center of the arm very slightly and get a little more tension BUT the arms are over 15 years old and teh springs are probably weak

Apr 20, 2009 | 1994 Jeep Cherokee Country

1 Answer

I HAVE A 94 JEEP GRAND CHEROKEE, BATTERY WILL NOT HOlD CHARGE. I REPLACED ALTERNATOR, BATTERY AND ALL CABLES. STILL WILL NOT START WITHOUT JUMP RUNS FOR 5 TO 10 MILES DIES WITH DEAD BATTERY. WHAT ELSE...


Check the Belt Tensioner. If the Tensioner is not Keeping the Belt Tight it will Drain the Battery Pretty Fast.Please Rate my Response, I need all the Help That I can Get! Thanks!

Jan 27, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1994 Jeep Grand Cherokee Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...