Question about 1992 Buick LeSabre

Open Question

Changing the time on the stero radio - 1992 Buick LeSabre

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to enter radio code

usually the volume dail will slecet the numbers so say if u have a 7 in the code u would turn the volume controll. do u have the instructions for said stero? if not googled it. it will go through things step by step. be carefull cause if u get it wrong to often it will lock ur stero completey

May 17, 2014 | 2003 Acura 3.2TL

1 Answer

Why is there no power going to my stero unit

Have you checked your radio fuse. Have you recently changed your radio if so are all power wires hooked up?

Jun 25, 2013 | 1985 Chevrolet Monte Carlo

1 Answer

Color to insatll a new stero

Here are the colours of the factory radio harness and what they do.
1995 Toyota Camry Car Radio Installation Schematic
Car Radio Battery Constant 12v+ Wire: Blue/Yellow
Car Radio Accessory Switched 12v+ Wire: Gray
Car Radio Ground Wire: Brown
Car Radio Illumination Wire: Green
Car Stereo Dimmer Wire: N/A
Car Stereo Power Antenna Trigger Wire: Black/Red
Car Stereo Amp Turn-On Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Tweeter Size: N/A
Car Audio Front Tweeter Depth: N/A
Car Audio Front Tweeter Location: N/A
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Purple
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Blue
Left Rear Speaker Positive Wire (+): Black
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Red
Right Rear Speaker Negative Wire (-): White

Jun 21, 2012 | 1995 Toyota Camry

2 Answers

How to reset the stero in a mercedes

I assume you have the radio code that came with the car????Disconect the battery cable and reconnect,that should reset the radio where you can enter the code.You will also have to reset the windows by holding down thw window switches once the reach the lowest and highest travel.the face plate on the radio should say code to be able to enter the code.

Feb 12, 2012 | 1999 Mercedes-Benz CLK

2 Answers

Does any radio work for a 1986 camry?

As in aftermarket like a Sony or Kenwood or..???? Yes.
The easiest way to install one is to get an installation kit. One that has a bracket/face that fills the hole in the dash and the new radio sits in and a wire harness. The harness makes things so simple. You don't need to know what wire color is what. The cars factory harness plugs right in and the new radio wires will be the same color on the harness.

Sep 06, 2011 | 1986 Toyota Camry

1 Answer

Cannot turn on power for stero OR command surface

if your battery has died or you have had it changed radio could be locked. if this has not happend check the radio accesory fuses on fuse panel. the owners manual can help you locate it. if all the fuses are fine you will have to have the radio/nav unit serviced.

Dec 22, 2010 | 2007 Mercedes-Benz ML350

2 Answers

Had dead battery in 2002 honda civic got jump now word CODE in radio display

try disconecting the positive terminal of the batery for sevral minets (5-10) this will reset the brain box memory for the stero aswell as for the car it self.

what caused the batery to go dead in the first place?
things that i can think of :
1) left headlights on over night
2) bad altenator not charging batery
3) battery is old and not taking a charge anymore
4) new stero installed incorectly and drainging the batery
have you resently installed a new stero or amplifyer?
is the turn key igntion system hooked into the amp/stero antena lead so that thy are shut of when the ignition is?
of note: new streo >theres a blue wire marked ant that goes to the amplifyer if not there you need to find the orange accsesory wire coming from the turn key igntion>check for power when ignition is in the on & off states could be yellow in some cars but is usaly orange if this wire has on and of state controled by the turn key igntion this would be the wire to tap into for the amplyfire and the radio main power
check your radio's instaltion guide for code errors
its posible that when hooking up the jump it was done incorectly and blew up the radio
ie postive and negative where fliped
hope this helped :)

Feb 24, 2010 | 2002 Honda Civic

1 Answer

I just reassembled my truck dash after installing a new heater core and now my stero speakers do not work, there is power to the actuall stero though. what is the problem.

From what you say I would check to be sure the factory stereo speaker plugs are plugged in tightly and deeply into the radio or radio harness. If you check this and still have no sound find the speaker wires at the radio and try to put an after marker speaker on the wire. There are two wires from the radio to each speaker so be sure you get the right ones. Let me know how this goes.

Jan 17, 2010 | 1998 Ford F150 Regular Cab

1 Answer

Blown stero fuse Hyundai Elantra 2008

look for any fuse under 7.5 amp also their is a fuse either inline or in the back of the radio .Better without any noise in the car though ,less distraction

Jun 30, 2009 | 2008 Audi TT Coupe

Not finding what you are looking for?
1992 Buick LeSabre Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides