Question about 2004 Toyota Sequoia

Open Question

Where is the fuse for the side mirrors?

2004 Toyota Sequoia - Where is the fuse for the side mirrors?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

dgjtex
  • 405 Answers

SOURCE: The oil gauge in my

have you changed the oil sending unit, this is the most probable cause.

Posted on Jan 07, 2009

  • 1986 Answers

SOURCE: Replacing the driver's side mirror on Toyota 2004 4 unner

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Posted on Sep 29, 2009

  • 63 Answers

SOURCE: I need a fusebox diagram for the inside fusebox on

its not on the inside of the fuse box cover?

Posted on Oct 22, 2009

  • 4336 Answers

SOURCE: how to program garage door opener on 2004 toyota

You may find that this porcess is with your GARAGE DOOR opener and not the car. Rolling code technology units require that you press a button on your opener motor, (get a ladder and a light, get up there and read it, have an assistant in the car to press). what you do is press the button on the opener, to accept input signals, then you press the button in the car. Usually you get a flash on the opener's lights, then that sender (car) is accepted.

Posted on Jul 26, 2010

swolfinor
  • 504 Answers

SOURCE: programming garage door opener 2004 toyota sequoia

GOTO HOMELINK.COM
THEY HAVE THE INSTRUCTIONS FOR ALL OF THESE UNITS.

Posted on Jul 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Toyota Sequoia interior drivers side fuse panel noise.


If the battery is getting old, the clicking could be an indication that it is due for replacement.

Jan 18, 2014 | 2004 Toyota Sequoia

2 Answers

How to disconnect the motor on a driver's side mirror


Remove the drivers door panel and the connector is right there

Feb 24, 2012 | 2006 Toyota Sequoia Limited

1 Answer

2004 Sequoia B2S1 o2 sensor - where is this located and is it easy to replace? Thank You!


Toyota Sequoia has 4 oxygen sensors... two on each side. The ones in front of catalytic are position one, and, after are position 2.

Bank 2 is on passenger side, Bank 1 is on driver's side.

Hope this helps (remember to rate and comment this free answer).

Sep 21, 2011 | 2004 Toyota Sequoia

1 Answer

The driver's side mirror motor that brings the mirror toward the car when in a car wash or a tight parking spot seems to be stuck running. It will only stop when in the inward position or the car is...


if it was a bad fuse it would be dead, not stuck on. i would replace the switch before i replaced the mirror, sounds like a function of the switch is bad.

May 06, 2011 | 2004 Toyota Sequoia

1 Answer

The ac light on my Toyota Sequoia just started blinking and the ac started blowing warm air, uh oh..


replace the A/C magnetic clutch relay, its in the under the hood fuse box

May 05, 2010 | 2004 Toyota Sequoia

1 Answer

Want to fix the passenger side mirrow motor for toyota sequoia 2005


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can remove the bolts holding the mirror onto the door and disconnect the cables from the mirror going into the door

Sep 03, 2009 | 2004 Toyota Sequoia

Not finding what you are looking for?
2004 Toyota Sequoia Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...