Question about 2002 Volkswagen Jetta TDI

Open Question

How do I change a headlight bulb in movano van 3500

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fit a side front off side bulb in my 2002 ford escort van diesel 55


Instructions
  1. Make sure the the headlight switch is in the off position.
  2. Open the bonnet to the Escort.
  3. Locate the back side of the headlight assembly to the headlight that needs to be changed (driver's side or passenger side) from inside the front the engine compartment.
  4. Unplug the wires from the back of the bulb.
  5. Turn the back of the bulb housing counterclockwise one-third of a turn until the bulb and wire harness are released from the headlight assembly.
  6. Unplug the wire harness from the bulb socket.
  7. If using Halogen headlight replacement and be careful not to touch the glass bulb part. Handle it by the socket at the bottom of the headlight.
  8. Plug the wire harness into the new headlight replacement.
  9. Align the tabs on the headlight housing to the slots in the headlight assembly and insert the bulb into the assembly. Twist the headlight one-third of a turn clockwise until it locks into place.

Dec 03, 2014 | Ford Cars & Trucks

2 Answers

Dodge ram 3500 turn signal - headlight problem


WAY TO GO !!! another "great idea" from vehicle manufactures

Jun 07, 2012 | 2004 Dodge Ram 3500 Truck

1 Answer

How to change the globe to the headlight of my Kia Pregio GS 2005 van


To replace headlight bulb of kia pregio van: You only need Phillips screw driver and 10mm socket or open wrench. Open the hood, remove front grill with 4 phillips screw. This will give you room for your hand to pull out the headlight housing later on. Next is remove the signal light housing by unscrewing the phillips screw on top of the headlight housing then pull out the signal light housing and remove the bulb. You will see 2 pcs 10mm bolts on the side which hold the headlight. Loosened and remove the bolts on headlight holder then pull the headlight sideward. Remove power supply socket before removing it completely from the van. Remove bulb socket, spring clip, and busted bulb and replace with new one. Reassemble the disassembled parts in reverse order. That's it, will take you only 10 minutes.

May 27, 2011 | Kia Rio Cars & Trucks

1 Answer

Replace headlight chevy express van 3500


open engine compartment, reach in behind headlamp housing and twist the outtermost ring on the headlamp bulb to reslease it from the lamp housing.
Being careful not to touch the new lamp bulb... replace the new bulb in reverse of the removal.

Feb 19, 2011 | 2002 Chevrolet Express

2 Answers

I have a vauxhall movano 3300 CDTI will only start with easy start even when hot but it drives great Help.


hmm have to think about this ,has anyone changed the timing belt?? or if its common rail then dealer only to diagnose the fault

Jan 23, 2010 | 2002 Volkswagen Eurovan

2 Answers

Dodge Ram 3500, Headlights are dimmer than they should be.


Hmm. Ok this can be one of two things.
1: Check your grounds, a bad ground will kill the voltage going to the headlights. Find the wires and run them down until the wire somewhere connects to the body by a small bolt or screw. Unscrew the ground and then make sure the connection is not rusty nor painted over. You may want to be bare metal on bare metal. Thats your best bet.
2: Your second solution may be that your alternator may be dragging on the battery causing the headlights to dim. Check that by revving the engine up a little bit and see if the headlights get any brighter. If they do not, It should be the grounds. Also, check if there any other bulbs around the truck that may be out. Just like christmas lights, one bulb goes out, it effects the rest.
Hope this helps. -Steve

Dec 06, 2009 | 2004 Dodge Ram 3500 Truck

2 Answers

Lightbulb driver side 2008gmc 3500 6.6l


how to change driver side headlight bulbs?

May 30, 2009 | 2008 GMC Sierra 3500HD 2WD

1 Answer

Signal light change.


There is one 10mm Bolt on the top of the light and three 10mm nuts on the back of the light. You will need to use a 10mm wrench to remove the nuts because they are in a tight place.

After the 1 bold and 3 nuts are removed, the entire headlight assemble will pull straight out. You don't need to take the headlight bulb out because there should be enough wire to pull out the assembly far enough to get to the turn signal bulb. This will allow you to change the turn signal bulb which should be a 4157 amber bulb.

When putting the headlight assemble back in the van, there is a plastic pin in headlight assembly that goes into a hole in the front fender for alightment. Don't force the light. Take your time and the headlight assembly will go back in the van smoothly.

Mar 17, 2009 | 1999 Plymouth Voyager

2 Answers

Movano van


i have just bought a v reg vauxhall movano when i put the key in the ignition the immobiliser light goes out but the engine wont start any ideas

Feb 27, 2009 | 1999 Oldsmobile Intrigue

Not finding what you are looking for?
2002 Volkswagen Jetta TDI Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...