Question about 1998 Isuzu Trooper

1 Answer

Removal of the right side cvshaft on a base 1997 dodge avenger

I have a 1997 base dodge avenger with a broken left shaft. Half is out other have still in diff. I have tried a cv fork, I think its called, no luck. I have tried a hammer, same thing. Do I need a special tool? Also there is a braket holding the shaft in place, mid shaft ,do I need to take it out.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 389 Answers

REmoce the rubber boot. Clean away all the grease from the joint. Rub your fingernail on the 3 tracks which the drive end slides on in the diff. Near the outside you will find a round wire like spring clip push a small screwdriver under it and and take the clip out. The drive end will slide out.

Posted on Oct 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Keyway broken on the crankshaft


is the shaft damaged or did the little key piece get damaged they can be replaced ?

Dec 11, 2013 | 1997 Dodge Avenger

1 Answer

Getting cold air only on right side of heater assy, hot air on left side


you most likely have a bad blend door motor, or the actual door is broken inside the heater box. Jeeps used to have this issue, the door shaft snaps and only half will work. If you can turn from hot to cold on the side that's warm, then that's most likely what is going on.

Dec 07, 2013 | 2009 Dodge Journey SXT

1 Answer

Where is the computer on a 97 dodge avenger located and how do I remove it?


The engine computer is under the hood in the front corner on the drivers side. There is also an automatic transmission computer right next to it. The engine computer is the one closest to the front of the vehicle.

They are just held in place with a couple or 3 bolts.

Oct 11, 2010 | 1997 Dodge Avenger

1 Answer

Digram for a 1997 dode avenger es cv half shaft for drivers side..( to remove)


Welcome To FixYa.com,


Regards, Lee Davidian

A 4'''' Thumbs up is appreciated so please take the time to rate me. Testimonials are accepted,

Thank you, Lee Davidian7ee3431.png07e88e6.png782add7.png

Oct 03, 2010 | Dodge Avenger Cars & Trucks

1 Answer

Where is the egr located on a 1997 dodge avenger es with a 2.5L V6


The egr itself is on the backside of the engine closest to the firewall towards the driver side. You have to lean past the intake to get to it. The resonator is about 4-5" to the left (passenger side) of it.

Sep 09, 2010 | 1997 Dodge Avenger

1 Answer

I have a 2004 dodge ram 2500 4x4 . the front drive shaft has a ball kit in it . how do i replace this and how does it work?


If it is the tipical cvshaft you must replace the whole shaft if you have the old style straight axle you have to take the four wheel assembly apart remove the rotor assembly this means that in some Dodges you have to have the bearing unpressed and a new bearing installed when you change the universal joint in the wheel shaft good luck these are tuff to do

Feb 24, 2010 | 2004 Dodge Ram 2500

1 Answer

How do I tell if the half shafts need to replaced?


on a hard turn they will click if the cv is bad... turn hard left and bad right will click turn hard right bad left will cilick...usally quiet going strait...unless there really bad!!

Jul 23, 2009 | 1995 Dodge Avenger

1 Answer

I have a 1997 dodge avenger ..right headlight and quarter light don't turn on i checked every fuse they all work did miss something?


sounds like you have a broken wire or a bad ground. check to see if the wires to the front right are rubbing on a sharp edge or have gotten pinched.

Jul 18, 2009 | 1997 Dodge Avenger

3 Answers

1997 dodge avenger turn signal probs and location


replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace

Mar 20, 2009 | 1997 Dodge Avenger

3 Answers

Battery changing


Ok, trust me on this one, take the drivers side tire off and remove the forward inner fender panel. If you try it without removing the tire, it is just a royal pain.

Aug 25, 2008 | 2008 Dodge Avenger

Not finding what you are looking for?
1998 Isuzu Trooper Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...