Question about 1995 Ford Bronco

2 Answers

Location of map sensor for 95 ford bronco - 1995 Ford Bronco

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where can you buy M A P sensor hoses or a set, for a 1987 Ford Bronco Full Size 5.0

Posted on Feb 06, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Ford Expert
  • 234 Answers

Do you mean he MAF sensor? If this the case it is attached to the air cleaner box. It has the inlet hose on it from the box to the throttle body.

Posted on Oct 08, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Troubleshooting


Looks like you have changed about all the sensors with exception of the Mass Air Flow Sensor mounted on the air filter housing, and the Oxygen sensors. I would venture to say it is the MAFS, mass air flow sensor.

Aug 16, 2013 | 1991 Ford Bronco

2 Answers

Where is the location of mass airflow sensor on 1988 ford bronco2


This engine doesn't use a MAF sensor, it uses a different kind of sensor to measure air flow, it is called a MAP (manifold absolute pressure) sensor, it is about the size of a pack of smokes and has a single 7/32" vacuum hose going to it from the upper intake manifold, it should be on the engine compartment fire wall. See picture below.

emissionwiz_230.jpg

Sep 21, 2011 | 1988 Ford Bronco II

2 Answers

Locate the ICM on a 95 bronco 5.8L (ignition control module)


On 1995 Ford Truck Bronco 5.8L EFI 8cyl the Control Module-Ignition is located under hood, center, upper engine area, front of intake manifold, mounted on front side of distributor.

zjlimited_1625.jpg

Fig. 1: A TFI-IV ignition module



Hope this helps (remember to rate and comment this free answer).

Jul 26, 2011 | 1993 Ford Bronco

1 Answer

Where is located the map sensor in a bronco 302 1988,


Firewall. Passenger side. About the size of a deck of cards & laying flat. Wiring harness and 1 vacuum hose hooked into the front of it. See the picture below.The Map sensor circled in blue. helpmech.jpg
--------- Thanks.Helpmech.

Nov 14, 2010 | 1988 Ford Bronco

2 Answers

WEAR DO I FINED THE SPEED SENSORD ON A 1995 FORD BRONCO


IT WOULD BE ON TRANSFERCASE OUT PUT SHAFT END.

Jul 03, 2010 | 1995 Ford Bronco

1 Answer

Abs light is on and the speedomter jumps


Check the vehicle speed sensor at the transmission.

Jun 18, 2010 | 1995 Ford Bronco

1 Answer

Need location of map sensor 3.8 engine 95 windstar


this engine dos not use a MAP sensor it uses a MAF sensor, the MAF is located in the fexiable rubber air intake hose from the air cleaner to the engine. see photo.


1f629d6.jpg

Feb 03, 2010 | 1995 Ford Windstar

1 Answer

Rough idle up and down 1988 ford bronco has a new Idle Air Control Valve was thinking it could be the MAP sensor or the coolant temp sensor anyway tho check either of these.


Try discoonecting the battery for a few minutes, and then reconnect and drive it, it may have to "relearn" proper idle speed.

Nov 06, 2009 | 1988 Ford Bronco II

1 Answer

My 1986 ford bronco cuts out at about 3/4 throttle acts like it has no power this started about 2 weeks ago. before that the throttle stuck open and I had to climb up and adjust the air cleaner it seemed...


I had a simular problem recently. The cause of my problem was mainly the MAP Sensor located on the firewall i then also replaced the catalatic convertor and muffler and the problem went away. Hope this helps and best of luck to you

Sep 30, 2009 | 1986 Ford Bronco

Not finding what you are looking for?
1995 Ford Bronco Logo

Related Topics:

795 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...