Question about 2006 Mazda 3

Open Question

2005 Mazda 3- My AC/Heater stopped working. The fan won't even turn on. =(((( The AC light turns on and I can hear it switch, its just the fan won't blow anything out... What should I do? and the estimate to get it done...

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: blower not working on ac or heater etc.

A very common solution here is replacement of the blower motor resistor. The resistor when they break do one of two things.

A. work only on high

B. dont work.

This item is located on passanger side under dash and is usually held in with two small bolts on either side with an electrical connector seperating the mounting screws. It is mounted right in the air box. I replace at least one of these a week in my shop very common item.

Posted on Nov 04, 2008

Ad
  • 2039 Answers

SOURCE: Heater blows cold, and fan switch only works on 4 and 5

working on 4 and 5 speed that the resistor that broken cold air you got to move the selector to see the motor that move the trap hot and cold sometime when the motor was not move to the hot side for a long time its jam the motor on the passager side under dash put to hot and gently tap the motor tanks pierre

Posted on Nov 09, 2008

  • 91 Answers

SOURCE: Blower fan not coming on

Sounds like you have a bad blower resistor. Its usually part of the switch. It takes about an hour to fix and the part runs about $70.00.

Posted on Apr 10, 2009

  • 347 Answers

SOURCE: I have a 2006 mazda 3 and the control dial for the

check the wiring connection, it may be loose. check the fan switch.

Posted on Nov 27, 2009

teemossinmia
  • 265 Answers

SOURCE: 2001 Mazda Tribute (3.0 L) Heater motor functions on high only

Its the Blower Resistor....If it was the switch, it probably wouldn't work at all....But the Resistor will give you those symptoms, of working on high med or low

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No air in front but i have air in rear is there a belt in front ??


Can you hear the front ac/heater fan? They use the same AC compressor so that should be okay. The fan switches fail quite often on those. That controls how much air is pushed by the fan for AC, heat and defrost. The switch is attached to the fan knob on the dash.

Aug 29, 2014 | 2005 Chevrolet Suburban

1 Answer

My heater/ac fan sometimes won't work. What do I check first?


$24the AC light does not light until you turn the fan on, that is ok, the issue with your fan only working sometimes is more than likely a faulty blower motor, in some cases it is the switch, when the motor does not turn on try tapping it and see if that makes it work, if it does then it is the motor.
the switch at autozone is part number SW295 and is $16
the motor at autozone with the blower wheel is part number PM136
cost is $24

Sep 29, 2012 | 1998 Pontiac Grand Prix

1 Answer

Chevrolet Suburban Fan Won't Blow


check ac control unit if you replaced blower module and if your sure fan works

Jul 09, 2012 | 2005 Chevrolet Suburban 1500

1 Answer

My heater switch only work on 4 it won't blow On 1 2 or 3 then when I put it 4 the ac turns off


check the speed control chip,is located behind the glove compartment just unpluged and remove the two screws,you have to remove the glove compartment,good luck.................

Aug 17, 2011 | 1999 Mazda Protege

1 Answer

OUR 04 TRAILBLAZER, THE A/C STOPPED WORKING, IT WOULD WORK SOMETIMES AND BLOW COLD AIR NOW NOTHING COMES OUT, OR THE HEATER TOO.. LITTLE AIR WILL PULL THROUGH IF ON THE HIGHWAY, I CAN HEAR IT CLICK OVER...


a couple of things,1 blower motor fuse.2 blower motor gone out.3 switch on fan speed control switch not sending signal to fans.after checking the fuses.next check theswitch on control panel.set ac or heater.if fan still doesnt come on then replace it.when it work and then stops working there are a lot of possiblities that caused the prob relay too not fliping over inside staying close loop.hope this helps.

Aug 16, 2010 | 2004 Chevrolet TrailBlazer

2 Answers

Strange Problem Bravo Ute Air Conditioning


the blower motor has no affect on the AC system,
start the engine and turn on AC and watch the AC compressor to see if clutch engages,if it doesn't the system isn't full,if you are correct the clutch should be engaged and should quit when you change heater speeds,

Dec 23, 2009 | 1988 Mazda B2600 Cab Plus

3 Answers

The heater/ac fan only works on speed settings 4 & 5


you might check your switch sounds like to me that your two lower speed sides of the switch maybe burnwed out.

Dec 19, 2009 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
2006 Mazda 3 Logo

Related Topics:

791 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...