An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has answered 20 questions.
Re: how to remove frt bumper on 325 bmw
Remove 8mm screws at r and l side splash sheils, remove t 50 torx bolts under bumper cover on either sdie of where the front lic plate cover goes, pull away from body of vehcile and disconnect the fog lights if equipped
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Four 8mm screws respectively hold in the head lamp. Two located right on top of the head lamp and two more below. Using a magnetic 8mm socket with an extension helps. Then the lower trim below the head lamp has to be pulled out, those are held in by a plastic tang on a plastic hook. Wiggle and see if you can remove it, if not then I'm afraid you'll have to drop your bumper, or at least one side of it in order to pull it out.
I would tape up the face/lenses of the head lamp before moving it around. Last thing you want are scratches on it.
remove rear seat, it's just clipped in. remove fuel pump acces cover gasket, pull out fuel pump assembly. Hold off smoking till later. order online new pump for a third of the price. reinstall. bingo...done.
this problem could be cause by a few things, the first thing to check would be the operation of the air fuel sensor and the next thing i would look at would be to check for proper fuel preasure. the preasure spec is 50psi. and the volume spec is that it should pump at least 1.85 L in 30secs.
you must remove glove box,remove lower cover below glove box, get under dash and use flashlight and you will see the fan resistor in the evap box, it maybe held in with a t 20 torx screw otherwise pull aside tab and pull out
best bet is going into frt right head light make hooke out of hanger and inbetween headlight and bumper twards the hood look for safty cable and pull on it , or jack frt right , remove wheel , remove frt part of inner fender cover right side and behind head light there should be the cable , pull on it .
you have to squeeze your hand through the gap in the engine bay turn the casing to unlock the bulb from the hosing remove the bulb and replace it.
For more room to manouvre remove the air filter box and you will have plenty space