Question about 2000 Chevrolet Blazer

1 Answer

Battery is fulling charge, altantor is new, but have no power what could be wrong

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 534 Answers

Check battery terminal posts are clean and firmly attached,
Check +12v supply fusible link (and/or in line maxi fuse) is not blown,
Check battery ground and chassis ground connections are in good order.

Posted on Oct 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 92 gmc k1500 pickup with a 350 throttle body motor in it we couldnt get the alternator to charge so we cleaned all the grounds and put a new alternator and new battery now its way over chargeing...

either that cable going to the battery is shorted to ground somewhere (maybe on the body of the alternator) or the alternator is defective. there is a chance that you put one of the wires wrong on the alternator and you are forcing it into full field mode. that is a mode we use to test the full output of an alternator. if an alternator stays on full field too long (more than ten seconds) it could fail.

Mar 06, 2013 | Cars & Trucks

1 Answer


I would check for voltage at the starter from the battery and from the key switch via the neutral safety switch.
If there is no voltage at the starter from the battery check the fuseable link wires and the ground connections.

Sep 05, 2012 | 2000 Ford Crown Victoria

1 Answer

How do I change my altantor

First you will have to locate the tension arm that keep the belt tight. You will then loosen the belt and disconnect the alternator. Depending on the vehicle there are 2 or 3 bolts. Make sure to disconnect the battery before doing anything. You will also have to remove the electrical leads that come out of the unit. Pick up the replacement part and install it doing this in the reverse order that you uninstalled it. Make sure to take the old one back to the parts store that you purchased the new one from. There will be what is called a core charge. You give them the old and they give you the new and you will be credited for it.

Aug 31, 2012 | 2006 Ford Taurus

1 Answer

1993 lumina sedan wont start pror to going dead that day lady said it was hard to start. thinking its a bad battery car wont start with a jump has power for radio and dime lights doesnt even click when key...

first of all. check voltage at battery with engine off. it should be at least 12.6 volts or better,less then 12 volts battery is bad. when running if alternator is ok. it should read at least 14.1 to 14.7 with accesories off. if less than 14 volts alternator is bad. make sure battery posts and cable clamps are clean and tight. also check the cable to starter for corrosion. if all is ok, then the starter or solinoid is bad. check fuses first !

Mar 12, 2011 | 1993 Chevrolet Lumina

1 Answer

When the fan kicks on a abs and the traction control light flashes on for a bref sec. I noticed it takes alot of power from the car. Not enough to shut it off but enough to notice it. I tryed to test the...

your electrical system is grounded somewhere thats why its losing battery power, your car is equipped with alternator design to power up the car electrical supply while running/ no you do not need a special battery to solve the problem all you need is a good car electrician..

Apr 07, 2010 | 2003 Volkswagen Jetta TDI

1 Answer

The altantor isnt charging

Take it off and have it checked,you may have to replace it.

Mar 21, 2010 | 1987 Ford Ranger

1 Answer

I have a 97 gtp I'm having a charging problem I've replaced the pcm, battery and the altantor. I have also tracked down the wire but the battery light comes on. The pcm reads 1.22, battery and alt read...

Hello! It sounds like you may have a fusible link issue. If you follow the wire from the alternator down to the starter (which would be the larger of the wires attached to it); near the end you will find the fusible link. If this is blown - your alternator will not charge the battery.

Hope this helps and good luck! Thanks for using FixYa!

Sep 28, 2009 | 1997 Pontiac Grand Prix

1 Answer

I just put a new starter in a 1994 oldsmobile and the car just clicks still and will not start what could be wrong with it

Usually not enough power. ensure you have a full charge in the battery and then try. You can identify this if you have another car battery to pull and try on the olds.

May 05, 2009 | Oldsmobile 88 Cars & Trucks

1 Answer

1993 cutlass supreme

Are you Sure the Alternator is Fine???? Sounds an Awful Lot like it is not Charging the Battery to Full Capacity.

Jan 22, 2009 | 1993 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides