Question about 2001 Oldsmobile Silhouette

1 Answer

Left front seat power seat stopped working. checked fuses all good

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 26 Answers

You might have a broken wire going to the seat follow wires back

Posted on Oct 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I just purchased a 2005 cadilllac srx v8 n i cannot get the third row seat tto function? Help?


Rear Seat Switches
There are three push button switches that are used to operate the power folding seat; front stow switch, rear stow switch, and recline switch. The front stow switch is located in the right rear quarter trim panel just behind the second row seat. The rear stow and recline switches are located in the right rear trim panel just inside the liftgate. Battery positive voltage is supplied at all times to all three switches from the FFS SW Fuse located in the left rear fuse block. The folding seat will operate only in a supervised mode, i.e. press and hold the selected switch button through the entire cycle of operation, or release the switch when the desired seat position is reached. When any folding seat switch is pressed, it sends a 12 volt signal through the switch signal circuit to the RSM. The RSM then commands the appropriate seat motors to move in response to the switch signal.
Rear Seat Module and Power and Ground
The rear seat module controls the position of the third row seat. When commanded it moves the seat from the seated position to the stowed position, or, from the stowed position to the seated position. With the seat in the seated position, the RSM can also move the angle of the seat back forward or rearward.
Battery positive voltage is supplied at all times to the module through the battery positive voltage circuit and the FFSM fuse located in the left rear fuse block. This voltage is used to power up the RSM and also to apply power to the seat motors when commanded. The RSM is grounded through the module ground circuit and G401.
The first place to start would be check the fuse's .Do you know where the left rear fuse block is located ? Fuse Block - Left Rear
In the passenger compartment, near the left side of the rear seat under the carpet
If the fuse is good next thing to do would be ,have check for DTC'S in the rear seat module ! This has nothing to do with check engine light or OBD 2 diagnostic trouble codes an a code reader for said OBD2 codes will not work . Would need a factory scan tool to check these codes.
DTC B1395
Battery positive voltage is supplied at all times to the rear seat load floor switch and the rear seat position switch by the rear seat module (RSM). The RSM monitors these battery positive voltage supply circuits for the protection of internal circuitry of the module.
DTC B1395 Device Voltage Reference Output 1 Circuit
DTC B1420 Device Voltage
Battery positive voltage is supplied at all times to the seat adjuster switch and the memory seat module (MSM) through the same circuit. The MSM uses this battery voltage input to determine if battery positive voltage is applied to the seat adjuster switch.
DTC B1545 Seat Stow Switch 1 Circuit


?€¢
DTC B1546, Seat Stow Switch 2 Circuit


?€¢
DTC B3729 Seat Recline Control Switch


DTC B1735 Seat Front Up Switch Circuit


?€¢
DTC B1740 Seat Front Down Switch Circuit


?€¢
DTC B1745 Seat Rear Up Switch Circuit


?€¢
DTC B1750 Seat Rear Down Switch Circuit


?€¢
DTC B1755 Seat Assembly Horizontal Forward Switch Circuit


?€¢
DTC B1760 Seat Assembly Horizontal Rearward Switch Circuit


?€¢
DTC B1815 Seat Recline Forward Switch Circuit


?€¢
DTC B1820 Seat Recline Rearward Switch Circuit


Just from looking at the factory service info , I'd say you would be bet off just taking this to the dealer !
The first plase

May 28, 2016 | 2005 Cadillac SRX

2 Answers

The drivers seat won't move and the heated seats won't work on both sides. Where is the fuse?


Check underneath the seat for an inline fuse. It is a glass type fuse in a fuse holder that you have to push and twist to get out.-----------------------------------------------------------------------------
XPROG-M

Apr 18, 2013 | 2006 Chevrolet Tahoe

1 Answer

Translating japanese to english on fuse box


is located under the dashboard on the driver's side. The fuse label is attached under the steering column. If something electrical in your vehicle stops working, check for a blown fuse first. Below table outlines detail fuse number, its ampere and circuits protected. honda-crv-interior-fuse-diagram-thumb.png
No.
Amps
Circuits Protected
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38
7.5 15 10 7.5 (15) (20) _ 10 7.5 7.5 10 10 10 7.5 7.5 10 10 20 15 7.5 20 _ _ (20) 20 20 (20) 15 15 20 (15) 20 20 7.5 7.5 10 7.5 30
Power Window Relay Fuel Pump ACG ABS/VSA Heated Seats* Front Fog Lights* Not used Rear Wiper ODS (Occupant Detection System) Meter SRS Right Headlight High Beam Left Headlight High Beam Small Light (Interior) Small Light (Exterior) Right Headlight Low Beam Left Headlight Low Beam Main Headlight High Beam Small Lights MAIN TPMS Headlight Low Beam Not used Not used Moonroof* Door Lock Front Left Power Window HAC Option Rear Accessory Socket Accessory Front Right Power Window Accessory Power Socket on the Center Table* Rear Right Power Window Rear Left power window ACC Radio ACC Key lock HAC Daytime Running Lights Front Wiper

Dec 13, 2010 | 1997 Honda CR-V

1 Answer

2006 dodge durango driver side front power seat just stopped working. Where is the fuse located for the power seat/what number is it in the fuse box?


I have a 2006 Dodge Durango. Drivers side power seat has stop working. Want to check the fuse, however unable to remove the fuse. Any suggestions on how to remove the fuse without breaking it?

Apr 19, 2010 | 2006 Dodge Durango

2 Answers

1999 Cadillac Deville Driver side power seat not working


No fuse.These seats are protected with relays and a seat module.The module is under the drivers seat.There are 3 connectors and it would be hard to check all these wires for power to the motors.First look under the seat and make sure none of the connectors came apart under the seat by something that might have been left or rolled under it.The 2 main ones you can check are the connector 2 terminal C and connector 3 terminal A.C is a black wire which is ground and A is a red wire which is the feed power wire.Connector 2 is green and 3 is black.If the ground and power wires are good then you could have a bad drivers seat module.What I would do is go to the salvage yard and find a used module to try.Good luck.

Dec 07, 2009 | 1999 Cadillac DeVille

2 Answers

The driver seat heater just quit. all fuses are good. how do you tell if the relay is good?


Swap it with a relay you know to be good and see if it works again,pick a relay that is not important to the function of your car.

Nov 01, 2009 | 2004 Cadillac SRX

1 Answer

2000 GMC Jimmy Power seat stopped working


Left side of the dash, to the right of the IP fuse block. Its a 25 amp circuit breaker, an aluminum cased breaker. CHECK FOR POWER ON THE SEAT SWITCH "A" TERMINAL AND GROUND ON THE "D" TERMINAL. IF YOU HAVE POWER AND GROUND THE SWITCH IS BAD.

May 27, 2009 | 2000 GMC Jimmy

1 Answer

1998 E230. power seats,central locking,power windows, turn signals, wipers, power mirrors all stopped working


hello,check your fuse number 4 ,15 for signal light ,check also the rear fuse box for power window,central lock,power seat ,located at rear seat in front of battery,ty

May 01, 2009 | 1999 Mercedes-Benz E-Class

Not finding what you are looking for?
2001 Oldsmobile Silhouette Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...