Question about 2006 Renault R5

Open Question

How to change the sidelight bulbs in a renault clio grande mk2

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: renault clio 1.2 2003 model

under spare wheel in boot ,,,,or under passenger seat LHD

Posted on Nov 25, 2008

Ad
  • 1 Answer

SOURCE: renault clio 2007 changing the front main lightbulb

it's a real nightmare to try to change it from inside..i tried and hardly succeeded on my clio campus 2007...yours is clio III, I suppose..so it should be the same system..you need a wrench tool of size 10 (mm)..and you will need to dismantle the front lapmp..don't worry..the level of the light beam is adjusted by the mechanism which is holding the light bulb in place, not the angle of the front lamp.

Posted on Dec 28, 2008

  • 10 Answers

SOURCE: how do you remove front grill on Susuki grand vitara

Remove the clips that secure the top of the radiator grille. Pry up the center piece and pull up the clip to remove it. There are 5 screws on the bottom of the grille piece that you have to take out. BE VERY CAREFUL with the grille when pulling it out as it idoesn't take alot of force to break it. Next undo the screws that secure the headlight housing (3 total), there is also something called a guide pin on the housing. Detach the connector from the bracket by squeezing the lock tip with pliers. That should give you complete access to the lamps inside the housing.

Posted on Apr 10, 2009

  • 1 Answer

SOURCE: renault clio 05 interior light bulb gone . It

remove it from the car, drilla largish hole in the plastic behind the catch, and use a screw driver to unclip it. it takes a bit of effort.

once you get it off trim down the lug for the next time so it comes out easier.

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front light cornering on Renault Clio not working have changed bulb and checked fusers


light no working
fuse or bulb not blown says the earth is bad

front bulb needs an earth to complete a circuit

Oct 29, 2016 | Renault Cars & Trucks

1 Answer

Hi, I started my Renault Meganne 1.5 dci diesel 2009 up this morning an turned the headlights on.


Check the relay box. If its like the clio the fumes from the battery corrode the fuse/relay box.

Oct 24, 2016 | Renault Megane Cars & Trucks

1 Answer

30 AMPFUSE KEEPS BLOWING ON MK2 CLIO UNDER THE BONNET TURNS OVER BUT WILL NOT START UNTILL I CHANGE FUSE


Will have to find out when fuse is blowing to find out what is causing it are you running an amp or had anything else done before fuse problem

Sep 22, 2013 | 2005 Renault 181

1 Answer

Need to change a head lamp bulb on a clio 2002 and finding it difficult , do i have to remove the hole lamp?


I know some Renaults such as the Megane have an access port within the wheel arch. You might try checking there. If there is one though, then it's likely easier to take the wheel off to get to it.

Nov 14, 2012 | Renault Cars & Trucks

1 Answer

Replacing a headlight bulb in a renault clio rs 200


Just changed my Front Headlight bulbs on a 2012 Clio RS Raider / Ange & Demon. Brought the bulbs from HIDS Direct in the UK. All done without removing anything but 2 nuts holding the rubber airflow pipe on next to the battery and twisting the hose to enable me to put my hand between the battery and the front light unit. The other side was even easier ! It is a tight squeeze to get your hand in there. Remove the rubber cap protecting the bulbs, pull the supply plug off the back of the bulb, then unclip the U clip holding the bulb in place and safely remove the bulb. You may need a torch to see where your going when putting the bulb back in and you might end up with some cuts on your hand from the tight squeeze. BUT its a 10 minute job Vs a hour job removing the bumber alone and light fitting :)

Jan 20, 2012 | Cars & Trucks

1 Answer

Clio mk2 ignition


so what is you want to know about a clio

May 31, 2011 | Renault Le Car Cars & Trucks

1 Answer

The light switch functions correctly with the


I have exactly smae problem with my Clio, if you have the cure please email me at p@remmington.plus.com

Jan 16, 2010 | 2002 Renault Sportwagon

1 Answer

My renault clio dipped beam light are not nworking


itll be the light arm there allways going yes the swich has gon thanks ben

Nov 16, 2009 | 2006 Renault Le Car

1 Answer

Renault clio 2007 changing the front main lightbulb


it's a real nightmare to try to change it from inside..i tried and hardly succeeded on my clio campus 2007...yours is clio III, I suppose..so it should be the same system..you need a wrench tool of size 10 (mm)..and you will need to dismantle the front lapmp..don't worry..the level of the light beam is adjusted by the mechanism which is holding the light bulb in place, not the angle of the front lamp.

Dec 04, 2008 | 2006 Renault 181

3 Answers

Renault Clio sport R Reg - leaking manual sunroof


word_answers.gif Betta Windsrceens Stockport have been repairing sunroofs for 30 years. What i will tell you is both the mk1 and mk2 clios have a problem with the sunroofs.
The sunroof needs to be taken out cleaned damming seal on frame removed and fitted back with silicone sealer excess sealer clean of with white sprite no need to remove head lineing if fitted with 10 mm bolts use a ratchet spanner. Mk1 clios also leak from the arial remove and reseal. And mk1 & mk2 have a problem with the bulk head filling up with water. Open bonnet on the back of the bulk head is a hose about 6 inches long which gets blocked un block and the water can drain like it did the day the car left the factory. bettabob

image_icon_name.gifbettabob
image_icon_date.gifFebruary 2009

Oct 13, 2008 | 2000 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

847 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

xxxxxx xxx

Level 3 Expert

4861 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...