Question about 2003 Chevrolet Blazer

1 Answer

I cannot remove the key from my 2003 chevy blazer ignition after turning it off. light stays on and drains the battery

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 269 Answers

Turn the igition to on,then off.Pull on the key while the igition is in the lock position at the same time turn the steering wheel left to right.The steering wheel will move slightly while in the lock position

Posted on Oct 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset antitheft on 2003 chevy. Blazer how. To


http://vatspasslockpasskeysecurityhelp.yolasite.com/

http://support-docs.newrockies.com/19982005_s10_blazer_jimmy_hombrev4


Perform the re-learning procedure
  1. Turn ON the ignition, with the engine OFF.
  2. Attempt to start the engine, then release the key to ON (vehicle will not start).
  3. Observe the SECURITY light, after approximately 11 minutes the light will turn OFF.
  4. Turn OFF the ignition, and wait 10 seconds.
Repeat steps 1 through 4 two more times for a total of 3 cycles/30 minutes ( the vehicle is now ready to relearn the Sensor Data Code and/or passwords on the next ignition switch transition from OFF to CRANK).

Sep 20, 2014 | 2003 Chevrolet Blazer

1 Answer

My ignition key is stays in on position wont turn car off


remove fuse when leaving overnite--the ignition lock or switch is bad or issue with wiring--junk yards have good used parts or bring it to an xperiencd mechanic not a dealer

Sep 15, 2014 | 2003 Chevrolet Monte Carlo

1 Answer

All acc power stays on and starter wont stop turning over when battery is connected in my 1997 chevy blazer


I would take a look at the wires down at the starter. He may have the large positive wire shorting to the smaller, trigger, wire. This could potentially cause a back-feed through the whole system.

Jan 28, 2013 | Chevrolet Blazer Cars & Trucks

1 Answer

1996 Chevy Blazer - I just noticed the clock light staying on. My battery is draining (just got a new battery already drained. truck has not been moved). What would cause the light to stay on and how do...


I highly doubt that the clock radio is drainng your battery. Check the under hood lamp, the glove box lamp, and if none of these lead you to the cause, the put a 12 volt test lamp between the battery neg, terminal( having removed it first) and the battery neg connector. If there is a draw, the lamp will light brightly. Remove fuses untill it goes very dim, and that will be the circuit that has the draw. Should be easy to narrow down after that! Good luck, and let me know what you find!

Nov 09, 2011 | 1996 Chevrolet Blazer

1 Answer

I replaced a new battery on my 2003 chevy tahoe, after I noticed it was completely drained. Now I am unable to start my vehicle. The dashboard is reading "driver unkown". How can I resyc back to...


Turn ignition key to run position so that red & yellow idiot lights stay on. Leave in this position for 10 minutes. At first you should see theft light flashing then it will go to on. Then turn key to off. Then start vehicle.

Nov 27, 2010 | 2003 Chevrolet Tahoe

3 Answers

When i turn the key I get no dash lights, 97 blazer


I had the same exact thing happen to me, I have a 97 blazer and after hours of screwing around with it and several different options... it turned out to simply be the ignition switch.

Feb 07, 2010 | 1997 Chevrolet Blazer

1 Answer

The Key won't come why out the ignition in my 03 Chevy Blazer


Steering lock has came to rest applying pressure to key. Slowly rock steering wheel from left to right while turning key.

Jun 30, 2009 | 2003 Chevrolet Blazer

2 Answers

Wiring diagram for 92 chevy blazer


My 1992 Chevy blazer s-10 starts and then the door locks automatically starts locking and unlocking...It wont stay running either...

Jun 11, 2009 | 1992 Chevrolet S-10 Blazer

2 Answers

Cant get key out


The ignition requires power to remove the key. A bad connection at the battery can cause this.

Jan 11, 2009 | 1997 Chevrolet Blazer

1 Answer

Chevy Blazer 1999,car doesn't keep running after started ,car has Passlock


hmmm, sounds like an ignition switch problem. Not the tumbler/key switch, the ignition switch.

Jul 19, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
2003 Chevrolet Blazer Logo

174 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...