Question about 1985 Jeep Grand Wagoneer

Open Question

1986 Jeep Grand Wagoneer - Alarm won't stop w/lead attached.

We have a 1986 Jeep Grand Wagoneer. We have now developed a minor glitch. We have had to disconnect the lead to the battery because every time it is attached an alarm sounds very loud and very insistently. I have tried turning key, locking and unlocking all doors and back tailgate, I have plugged and unplugged anything I could find to try to turn it off. Does anyone know how to disable the alarm or why it is going off like that? We didn't even know there was any type of alarm on the car. We do not have a manual for the car (it didn't come with one) so we don't even know what fuse it would be attached to. Thanks in advance.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76164 Answers

SOURCE: alarm sounding upon unlocking door with key

there is a sensor that tells the anti theft module you used the key to unlock the door, it is attached to the door latch or lock cylinder, u must have disconnected the wire to the sensor, so it thinks u are breaking into the car.

Posted on Feb 11, 2009

Ad
  • 290 Answers

SOURCE: Remote keys wont open vehicle

You can try calling a locksmith and see if they can get in. Locksmiths can use a tool to open the door by catching the rod inside the door frame. The last time I used a lock smith to open a door, it ran about $35.

I suspect once the battery issue has been resolved, you will need to reprogram the key fobs or figure out how to disable the alarm.

Posted on Mar 31, 2009

  • 232 Answers

SOURCE: Cant get 1996 jeep grand cherokee to start after alarm stopped

The alarm might have a relay to kill the ignition. Disconnect the negative or ground from the battery, wait five minutes then connect it again. This is to try and restart the alarm. Then lock and unlock the car to get the remote in sync. Try and operate your vehicle now and let me know.

Posted on May 06, 2009

  • 1 Answer

SOURCE: alarm going off by itself for no apparent reason

fuse is possibly under the dash

Posted on May 29, 2009

emissionwiz
  • 76164 Answers

SOURCE: Alarm sounds when unlocking driver door with key

replace the door latch disarm switch on the door latch

Posted on Jun 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the 93 jeep alarm the same as the 95


Yes, 1993 at 1996 have the same systems.

Feb 11, 2013 | 1993 Jeep Grand Cherokee

1 Answer

The engine in my 1994 ford crown vic is knocking from lack of oil how to stop it?


You probably won't.
If it has been run low on oil, the bearings may be damaged which would require replacement.
You could try a thicker oil but I doubt it will make much difference.

Sep 10, 2012 | 1989 Jeep Grand Wagoneer

1 Answer

I have a 1988 Jeep Grand Wagoneer that seems to be losing oil pressure then dying. I just changed the oil and the levels are fine. Not sure where to start... any ideas?


if this just started when you changed the oil and filter,then it might be the filter,it did it in my 89 jeep so i changed the filter to another brand and my oil pressure came back to normal.so i would recomend and stp or k&n or wix filter.if that doesnt then start looking at the oil pressure sensor and wire lead.you could also use a mechanical oil pressure guage and check it that way to.

Jun 01, 2011 | 1988 Jeep Grand Wagoneer

2 Answers

What is causing my 1986 jeep grand wagoneer engine to stall while driving? I cannot restart it but there is power. It will turn over but not start and there is gas in it. The jeep just went "poof" and died...


ok, its and old jeep, cranks but will not start.

carb fueled right? crank it wide open throttle to clean the flood
and block open the choke, if CARB has auto choke, if manual choke make sure its open. (push in knob... called choke)
fuses first. test them.
first check for spark in all cylinders.
if you have spark on all , then its flooded.
if no spark on one try a new spark plug and wire.
if all spark is dead , do the tuneup. now. all spark parts.
if spark is dead, check it at the coil, ? good there? or not.
that is a start.
if the carb is bad, we cant cover rebuilding it here.

stalls while driving has over 50 causes.
but bad spark or flooding tops list. (assumes engine is ok)

Oct 07, 2009 | 1985 Jeep Grand Wagoneer

1 Answer

1990 Jeep grand Wagoneer i ran out of gas,when i put gas in in the jeep the truck try to start but start draging then just did nothing,i try to jump it and steel nothing but just a clicking sound


by running out any debris in your tank will get sucked into your fuel pump. REplacing the fuel pump usually means removing the tank. You can try replacing the fuel filter first its much easier and cheaper. The filter is attached to your fuel line between the tank and the engine, usually in the frame. TAkes about 15 minutes to replace.

Jul 08, 2009 | 1990 Jeep Wagoneer Limited

1 Answer

My '89 Jeep Wagoneer won't start. It has a 6month


sounds like the starter actually have some one load test it for you, might be drawing more power then it need, hence the need for a jump

May 10, 2009 | 1989 Jeep Grand Wagoneer

1 Answer

1997 grand cherokee laredo fuel gauge alarm


Replace the gas tank mounted fuel pump - AND the filter and gas guage sensor. $300-440 at a dealer.
Get them to clean out the water and "gel" (its parrafin I think) from the tank. Insist they do it.

Nov 26, 2008 | 1989 Jeep Grand Wagoneer

1 Answer

1988 JEEP GRAND WAGONEER GAS GAUGE READS OVER FULL


The ground has corroded off the sending unit.You can access this by drilling out the rivits in the access panel under rear seat on drivers side.

Sep 30, 2008 | 1988 Jeep Grand Wagoneer

1 Answer

My 1985 jeep grand wagoneer cuts out and backfires when accelerating. Why?


if some one respond for this issue with this? I have same problem with my 1986 CJ7 jeep. please send me email if you have the solucion I alrady change the pickup coil,ignition switch, Module switch, the coil, I rebuilt the carburator and still doing the same think.

Jul 25, 2008 | 1989 Jeep Grand Wagoneer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...