Question about 2001 Ford Windstar

Open Question

After I replaced the battery the message center

2001 SEL Windstar Van. After I replaced the battery the message center quit working. Is there a fuse I can replace?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
alicantecoli
  • 22156 Answers

SOURCE: change oxygen sensor 2001 ford windstar

fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words

Posted on Jan 01, 2009

Ad
  • 5 Answers

SOURCE: 03 windstar message center is not working

Make sure you check the owner's manual for "running your car after replacing the battery." There is a process to follow. Maybe this will solve your problem.

Posted on Mar 31, 2009

  • 1986 Answers

SOURCE: Where are the kiddy locks on a 2000 Ford Windstar

on the sliding doors, next to the latch when the door is open, there will be a tiny switch that you have to flip. It may also be a hole in the door with a symbol that you have to slide your key into to engage or disengage it

Posted on Oct 08, 2009

  • 1 Answer

SOURCE: NO heat in front of 2001 windstar van. Thumping

where is the flaaper down located at in a windstar

Posted on Dec 04, 2009

Smith-alone
  • 360 Answers

SOURCE: Replace alternator 2001 ford windstar van

Hi, first you disconnect the battery. then you need to take the belt off by the back pulley. But you don't need to take it all the way off. Just so you get the alternator belt off. I just replaced the one on my 1997. Then you have three bolts, and one small nut to remove . Then put all back together the way you took them off.
Take care

Posted on Aug 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I drove my 2001 SEL Ford Windstar van home Thursday night and Friday morning when I tried starting the van not one thing happen; no sounds, no lights, key would not unlock the doors, not nothing. My...


Hi

It sounds like a broken earth wire, check the main one from the car battery to the car bosy, or to test it get a thick cable roughly the same as the "black" earth lead from the battery attach it to the car body somewhere and the other red to the battery terminal if the car starts you know it is an earth problem. they do often break off the gearbox on these models, so do check. there will be 3 main earth wires in total

Regards

Dan

Dec 28, 2010 | 2001 Ford Windstar

1 Answer

Replace alternator 2001 ford windstar van


Hi, first you disconnect the battery. then you need to take the belt off by the back pulley. But you don't need to take it all the way off. Just so you get the alternator belt off. I just replaced the one on my 1997. Then you have three bolts, and one small nut to remove . Then put all back together the way you took them off.
Take care

Aug 02, 2010 | 2001 Ford Windstar

1 Answer

2001 ford windstar battery being drained and i dont know why


I had this problem. i thought it was a parasitic drain but...
check your charging system. with the van running, check the voltage output accross the battery terminals. if its less than 14.1 check the inline fuse for the alternator (close to the alternator) if ok, replace the voltage regulator inside the alternator.

if the charging system is putting out 14+ volts then you need to start pulling fuses while van is off while monitoring the current draw between the positive battery post and the positive terminal clamp watching for a current drop. keep in mind the windstar will drain alot of current while off for the first 2 mins er so, then it will drop again in about 15 mins... time delay shutdown on several systems :)

May 01, 2010 | 2001 Ford Windstar

1 Answer

03 windstar message center is not working


Make sure you check the owner's manual for "running your car after replacing the battery." There is a process to follow. Maybe this will solve your problem.

Mar 28, 2009 | 2003 Ford Windstar

1 Answer

Change oxygen sensor 2001 ford windstar


fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words

Jan 01, 2009 | 2001 Ford Windstar

1 Answer

Need to replace number 1 sensor


Hi, it is very easy to change but have go repair shop, first when u get sensor, they have to heat the sensor with gas light that use in welding, the neck right from where it tied the manifold and put small engine oil, then start losing it, and dont forget to remove the battery terminal when doing the work,when it lose then disconect the wire that is connected to the point where it is connected and fix the new one by tieting it firmly to the position and fix back the wire and battery head and start the car u will see that the check engine light is gone

reagards

elmiskin3

Dec 31, 2008 | 2001 Ford Windstar

Not finding what you are looking for?
2001 Ford Windstar Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...