Question about 2006 Dodge Grand Caravan

1 Answer

Will not start. Makes loud clicking noise. Instrument Panel goes crazy. All needles go to far right.

Posted by on

  • eric_vanatta Oct 07, 2009

    We just replaced the car battery not even a year ago.

  • eric_vanatta Oct 07, 2009

    We just replaced the car battery not even a year ago.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 52 Answers

Sounds like your battery is very low. that clicking is your starter trying to work. but without enough power the pinion on the starter can't activate to crank the engine over. have the battery and alternator checked if possible.

Posted on Oct 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loud noises


could be a number of things you need to run a diognostics scan

May 23, 2013 | 1992 Acura Legend

2 Answers

My 2001 tahoe makes a loud clicking noise in forward motion. The faster you go and the warmer the vehicle is it goes away. Then in reverse it makes a loud scraping noise. Help plz.


how well does reverse work and check color and level of trans fluid with engine running and warm also feel for grittyness of fluid if gritty and browning your trans may be going out

Apr 01, 2012 | 2001 Chevrolet Tahoe

1 Answer

Drivers window wont go up or down properly and makes a funny noise


The teeth on the arm might be stripped or the window motor might be dying. You will have to take off the door panel to see.

Oct 21, 2011 | 1999 Subaru Forester

1 Answer

My gas gauge has been stuck completely horizontal for awhile until lately. Now it flickers like crazy all over the place and i hear a little clicking behind the instrument panel when it does. It goes extra...


Well, considering that the fuel gauge is an electrical device, I would say that is most definitely an "electrical problem". The challenge is to locate where the elecrical problem originates from.

A ground circuit is defiately a possibility. The instrument cluster shares a common ground with many different components. The main ground for the IPC is at the rear of the right cylinder head. This ground is shared with the window motor circuits. Also there is a splice that is shared is is S246 and is located in the main instrument panel wiring harness approximately 37cm to the right from the steering column breakout.
-Or you could just have a bad instrument cluster. The printed circuits have been known to deterriorate and lose contact with certain components, including the fuel gauge.

May 10, 2011 | 1997 GMC Jimmy

1 Answer

Instrument panel needles goes nuts back and forth then stop sometimes all at once, sometimes only one or two. all or most of the lights on instrument panel come on like ABS, BRAKE, BATTERY, ENGINE STAYS...


same thing happens with my 2000 windstar, if you could take the instrument panel out, and unscrew the the back of the instrument panel that covers the circuit board and clean the circuit with a brush, pure bristle brush is best 'coz they're stiff and gets all the dust that accumulated on the circuit board. some dust particles contain conductive material and shorts the circuit board and cause the trouble you have, ever since i did that no more trouble. and to those who are planning of replacing your instrument panel should do this first. it'll save you money. by the way i am a mechanic

Jun 25, 2010 | 1999 Ford Windstar

1 Answer

2004 Buick LeSabre. First noticed speedometer was


sounds like an instrument cluster failure or a computer problem.

Nov 22, 2009 | 2004 Buick LeSabre

1 Answer

Electrical Problem and now won't start


One common problem is with intrument cluster solder joints where the cable connector attaches to the circuit board. Solder joints fracture. Resolder. Use Hanes manual to get dashboard apart.

Indication is instrument panel goes dead and car sometimes will not start.

Other possibilites are loose connectors or poor connections in cable harnesses.

Jan 22, 2009 | 1998 Dodge Grand Caravan

1 Answer

Gauges gone crazy


Could need new instrument panel cluster but check for corrosion as the instrument panel connector

Aug 11, 2008 | 2000 Ford Windstar

Not finding what you are looking for?
2006 Dodge Grand Caravan Logo

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...