Question about 1998 Jeep Grand Cherokee

1 Answer

Truck keep cutting off on the road,i have replaced the tps sensor,crank sensor,ignition coil

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 284 Answers

Try checking your ignition switch sometime they might go back

normaly its just the crank shaft sensor, make sure you get the right one for your engine.

Posted on Oct 15, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2005 Silverado 4.3 No Spark at coil, Where do I Start ?


Since you have replaced all of the parts, perhaps the problem is the wires. Check continuity of critical wires. Are you getting power to the computer, ignition module and coil? Check continuity of wires from computer to ignition module and crank sensor. Check for bent pins and pushed back female terminals in connectors.

0996b43f80242500-gepcz2zwodkuqhqcnry40435-1-0.gif

Jul 31, 2017 | Cars & Trucks

2 Answers

2003 hyundai sante fe 2.4 shutter/cuts out at 3500 to 4000 rpm


clogged fuel filter weak fuel pump or faulty tps sensor.

Feb 17, 2013 | 2004 Hyundai Santa Fe

1 Answer

What causes ignition modules to go bad in 1991 delta 88


Generally the cause of an electrical component to fail is high heat or extreme voltage load.
Is the coil pack and module getting too hot from the heat of the engine ?
Is it shorting out because of oil or wet surfaces ?
Could you be loosing voltage to the module from the key switch ?
Are you loosing ground signals from the computer ?

Jan 22, 2013 | Oldsmobile Cars & Trucks

1 Answer

1989 f-250 5.0 engine cranks but won't start


  1. The ignition system on your 5.0L uses a distributor type system and will include the following components:
    1. Ignition control module (ICM). Depending on the year of your specific Ford, it'll have a inner-fender mounted ignition control module or a distributor mounted ignition control module. hot sure which you have.
    2. Ignition coil. you replaced it.
    3. PIP (Profile Ignition Pickup) sensor. This is Ford's name for the crank sensor and is mounted inside the distributor. The most common name for this component is the pick up coil.
    4. Distributor cap and rotor. you replaced
    5. Spark plug wires. you replaced.
  2. The thing to keep in mind about the ignition system is that all engine cylinders must get spark and the one thing that will stop the ignition system from creating spark on a wholesale scale is a BAD crank sensor.Have you pulled a plug then using some insulated pliers grounded it to the vehicle and turned it over to see if you have spark, that'll tell you alot.takes two people of course.Best of luck and hope this helps.

Dec 30, 2017 | 1989 Ford F 250

2 Answers

1990 Buick Lesabre keeps stalling


Check ecm for part number 1228253. If it has this number in it replace it with a 16198264. Gm had trouble with that ecm for a cutting off problem. Mine would stall driving down the road and when I would put it neutral it would start back up and not have any trouble for the rest of the day. You must set the tps with a volt meter or scan tool.

Apr 18, 2009 | 1990 Buick LeSabre

Not finding what you are looking for?
1998 Jeep Grand Cherokee Logo

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...