Question about 1994 BMW 3 Series

1 Answer

I have a BMW L reg 316 and wont start..? started up one day then cut out a few seconds later... since then, it turns over, trying to start and wont fire up. spark plugs are ok but arent sparking? any help? please?!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

Fuel pump packed in or fuel starvation. check these out first

Posted on Oct 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bmw 316 engine cutting out


try disconnecting air flow sensor or replace it with a known good one

Jan 01, 2013 | BMW 3 Series Cars & Trucks

1 Answer

Bmw 316 ti 1996 wont rev up theres fuel and spark but start it runs for 30 seconds then dies


check TDI crank sensor. It might be missing pulses due to some faulty plug or connection.

Feb 01, 2012 | BMW 316ti Cars & Trucks

1 Answer

Our BMW 318 wont start


try looking at the ignition lock/starter relay.as a fist step.

Jun 18, 2010 | 1996 BMW 318

1 Answer

Bmw m62 engine shurreding and trying to cut off?


It sounds like an inlet manifold seal. Try to rev the engine up to about 1500 revs, if it runs ok, then it's either that or your air-flow mass meter

Jan 17, 2010 | 2008 BMW 535i Sedan

1 Answer

I have a 2000 w reg bmw 316 runing slugish wen


get it diagnosed correctly before you end up buring up the catalytic converters.

Nov 01, 2009 | 2000 BMW 3 Series

1 Answer

Wont start 1995 bmw 525. just stopped on me pushed out of road day later it started and ran fine for 15 min. now it wont start unless it sits for a few days and is cool outside. when it starts last few...


next time it wont start, spray some starter fluid into the air intake on the engine, if it fires then you have spark, if not.....prolly a spark issue.

Jul 13, 2009 | BMW 525 Cars & Trucks

1 Answer

Engine cuts out


BMW CUTS OUT
A few things to check.
  1. Is fuel pump delivering enough fuel.
  2. Is injectors clean. Perhaps dirt in fuel. replace fuel filter
  3. Air leakage at top air intake of manifold at ICV idle control valve. Two hoses inside this housing prone to perishing.
  4. Throttle position sensor faulty.
  5. Mass air flow sensor faulty.
  6. ICV faulty or dirty. comon fault on older e36.
Havent done it yet but ICV is easy to clean according to internet. instruction available at bmw e36 blog. All off above can be tested by yourself according to manual.

Jun 28, 2009 | 1997 BMW 318

1 Answer

N Reg 1995 BMW 316I. Suspected fuel pump problem


Not a problem, the fuel pump is in the rear passenger side (under the back seat) pop out the seat held by too clips onto the the rear seat, take out the sound deadining pad, undo the big black cover and get water pump pliers too undo the white cover lift out the pump, you should check the fuel gauge to see how much fuel is in the tank, no need to drain as long as you dont want petrol on your hands.
When you take the pump out, the most common problem is the thin Brown wire snaps off the sender unit, it buzzes but wont start. It should be around £30 for a good second hand pump.

I hope this helps.

Jun 17, 2009 | 1995 BMW 3 Series

1 Answer

L Reg BMW 316 Dashboard failing


either a wiring problem or a circuit board problem from behind the clocks.there are 2 type of clocks for this specific model.any reputable bm breakers can sell u 1 4 30-40quid.it will take 5mins to do all u need is a torquescrewdriver.2 small screws at top of clocks just under the top of dash

Jul 31, 2008 | 1996 BMW 318

Not finding what you are looking for?
1994 BMW 3 Series Logo

Related Topics:

268 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...