Question about 2000 Ford Focus

1 Answer

Blowers Stopped Working Focus 99 1.6 Ghia

Hi All,
The blowers have stopped working completley,

checked fuses - ok
replaced resistor - ok

Still nothing, I read another post with the same problem and the fix was a loose earth. Where would I start or find this earth?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Check for power at the blower motor. then check if it has good ground . ground wire is black/orange and goes through blower switch, then to ground. If you ground the black/orange wire at the motor and it works, you either have a bad blower switch or wire connection (I do not have a diagram for your car, this is based on a 2000 2.0 focus) the wire ends up at the left A pillar. black wire.

Posted on Oct 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A/c stopped cooling a couple of weeks ago and now the blowers have stopped working too What could be the problem,all fuses are ok.


For the ac to stop working either the compressor clutch is not getting power or the gas is too low so the low pressure switch has switched the compressor off to stop sucking in air through the leak. The blower is controlled by the fan switch which is a 3 positional switch that has a resistor for each position. These resistors have a habit of burning out so the fan will not work. The resistors are in a block located in the blower housing. So you have two faults to fix.

Aug 31, 2013 | Mitsubishi Colt Cars & Trucks

1 Answer

Heat fan stopped working..is it a fuse?


Hi!!
It could be the Blower Motor Fuse or Relay and they should be located in the cabin Fuse Box, if both are OK, it could be the blower motor resistor, located on the blower motor housing, it is the part where the electrical connector goes into and it's got a pigtail connector that goes to the blower motor, it is attached to the blower housing by three screws. Here are some pictures for better identification.
FRONT VIEW 1kbron_5.jpg
CONNECTOR FROM RESISTOR TO BLOWER MOTOR 1kbron_6.jpg
SIDE VIEW 1kbron_7.jpg

To test it, make sure the electrical connector has voltage when the FAN is on, if voltage is present, it means relay and fuse are OK, plug the connector into the resistor and check voltage on the pigtail connector, if voltage is present, the resistor is OK, voltage varies according to the speed selected. To check the blower motor, apply 12 volts and ground the the motor terminals, it should kick in in Hi speed, if not Replace Blower Motor.
A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Nov 09, 2010 | 2000 Pontiac Grand Prix

2 Answers

My AC was first only working at the max setting now not at all


go for the reostat which is all in one with the blower motor ,expensive part though

Jun 03, 2010 | 2002 Pontiac Grand Prix

1 Answer

Fan blower stopped working


Hi Retta_roche,
This circuit is controlled through the switch. In the high position,it by-passes the blower resistor.So if the blower is off in the high position, and the fuse is good, you need to check the switch,blower motor or the wiring.Since the switch physically feels different,start there. Pull the switch and ground pin #4 blk/org wire with the key on. If the fan works,the switch is bad. You need to check the connector at the blower motor for evidence of a burn. If you find the connector burned,you will need to replace the motor and the connector. I am sending the wiring diagram to help you. If you need anything else,drop me a line. Thanks,Chuck d442985.gif

May 16, 2010 | 2000 Ford Focus

1 Answer

Air conditioner blower stopped blowing


It could be a fuse, or the blower motor resistor.

Jun 27, 2009 | 1995 Pontiac Grand Am

1 Answer

Subaru Forrester blowers in front not working


Since you have checked fuses and relays that only leaves the blower motor resistor pack. Here is a diagram of how to replace it. I hope this corrects your concern...
Blower Resistor (Manual A/C Model)

REMOVAL

105915171

  1. Remove the glove box.
  2. Disconnect the blower resistor connector.
  3. Loosen the two screws to remove blower resistor.
INSTALLATION

Install in the reverse order of removal.




Jun 08, 2009 | 2004 Subaru Forester

1 Answer

Blower motor stopped working


most common is the blower motor resistor or "module" going out. but if you have 12volts to the resistor the motor should work on "HI" but not on any other speed. if it doesnt work at all, you might have a bad motor. just to be safe id replace both. neither one is too hard to replace. three 5/16" bolts for the motor and two 5/16" for the resistor they are both under the glove box

May 05, 2009 | 2004 Dodge Grand Caravan

3 Answers

My blowers wont work tried fuses still nothing


If the blowers do not work on speeds 1.2.3 but are ok on speed 4 the most common fault is the heater resistor It is located behind the glovebox to the rh side

Oct 18, 2008 | 2000 Ford Focus

2 Answers

I HAVE A 1990 DODGE DYNASTY.HOW DO I FIX THE HEATER BLOWER THAT STOPPED WORKING?


it could be a 7 dollar resistor thats bad. Thats located behind the fluid washer resovoir.

Oct 08, 2008 | 1993 Dodge Dynasty

Not finding what you are looking for?
2000 Ford Focus Logo

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...