Question about 2005 Volkswagen New Beetle

Open Question

2005 TURBO BEETLE

WHILE DRIVING @ ANY SPEED THE VEHICLE LOSES POWER AND THEN STALLS ,REPLACED THE MASS AIR FLOW ...STILL DOE THE SAME THING BUT WHAT I HAVE NOTICE IS THAT IT IS GETTING WORST IF THE CAR HAS LESS THAN A HALF A TANK OF GAS , RIGHT BEFORE IT STALLS AS I AM LOSING POWER , IF I WERE TO COAST IN NEUTRAL THE CAR WILL NOT STALL
COULD THIS BE A TURBO PROBLEM? TRANSMISSION?

THERE ARE NO CHECK ENGINE LIGHTS

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 109 Answers

SOURCE: loses oil very quickly

If oil is truly coming from between the engine and trans then seal replacement didn't work or one of the soft plugs in the back of the block are leaking OR the block is cracked in this area (I HAVE seen this happen!)... did you look closely at the source of this oil? Are you sure that it's not the oil cooler seals (this is inside the fan shroud and hard to diagnose, but will will result in total oil loss within minutes!) Replace the oil, put the bug in the air, run it and watch the flow of oil while wiping with a rag to be sure of the source. If it's truly coming from between the block and trans, then pull the motor back out and thoroughly inspect with flywheel removed... also check that all the nuts and bolts holding the case halves together are tight... Hope this helps...;-)

Posted on Apr 14, 2009

Ad
pippall
  • 1486 Answers

SOURCE: 1999 New Beetle Turbo Check engine light and loses power

Change the air flow meter.That sounds like your problem.

Posted on Aug 08, 2009

  • 2 Answers

SOURCE: my vw beetle stalls out. the mechanic first told

If it was the mass air flow sensor, you will have a check engine light. The small rubber hoses connected to/from the mass air flow connector might have come loose or have a crack, which will cause compression to be too low. Check there before replacing the maf sensor.

Posted on Aug 27, 2009

  • 1 Answer

SOURCE: Why does my 91 VW Jetta stall out and lose power while driving?

I had a similar problem and the mechanic diagnosed it as a problem with the ignition coil. So you might want to get that checked.

Posted on Nov 11, 2009

FixinFax
  • 3085 Answers

SOURCE: Shaking engine, weak power, blinking check engine light

You have a bad coil pack, they usually crack from age and heat. It's best to replace them all. Check for a VW recall on this item.

Posted on Dec 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 kia sportage 4x4 its starts idles runs and then sometimes it stalls while driving cuts out and dies fuel pump has been replaced relays have been replaced fuses and fuel filters help!


Does your vehicle "hop" forward a bit when you are driving or coming to a stop. I had a similar complaint about my 2001 Pontiac Grand Prix and for me it was a mass air flow sensor replacement needed. The other thing it could certainly be is a clogged catylitic (sp?) converter. That will cause the symptoms your vehicle is having too. Good Luck. Hope this was helpful to you. Have a great day!

Aug 30, 2015 | Kia Cars & Trucks

1 Answer

2005 a4 while driving lose acceleration and power


Would really need more details on the vehicle. Petrol / diesel etc

Is the engine management light on? Are there any fault codes?

Power lose while driving is most likely to be caused by the mass air flow meter, leak at a vacuum or intake hose, turbo leak etc.

More details please........

Apr 02, 2014 | 2005 Audi A4

1 Answer

P0101


P0101: MAF or VAF A Circuit Range/Perf

- Dirty mass air flow sensor
- Dirty mass air filter
- Mass air flow sensor harness is open or shorted
- Mass air flow sensor electrical circuit poor connection
- Intake air leaks
- Faulty mass air flow sensor

Before replacing the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with low compress air or mass air flow sensor cleaner. Reset code and drive vehicle. If the code comes back, it may be necessary to replaced the mass air flow sensor.

Feb 09, 2012 | 1999 Pontiac Grand Prix

1 Answer

My 2006 VW TURBO TDI is sick- Help me


Changed the timing belt and knocked loose the wires or connections to the sensors on the mass airflow device.

Mar 03, 2017 | 2006 Volkswagen Jetta

1 Answer

My 2000 VW Beetle idles really rough and loses


I had that problem for the longest time. I had to clean the Mass Air Flow Sensor. Very easy to get to. Go to any auto parts store and ask them for the MAFS Spray. If cleaning it doesn't work, you may need to replace the MAFS. Once again easy to replace. Make sure you put it back nice and tight.....

Jan 04, 2010 | 2000 Volkswagen Beetle

1 Answer

2005 silverado lt 6.6 duramax diesel turbo..engine trouble code reads turbo low ???? when driving truck, stop to go up a hill, push pedle to the floor, no power and acts like not enough fuel to engage...


Before we do anything else lets do a fuel pressure check to make sure the pump is a-ok as well as the fuel pressure regulator. Your gonna need shop manual for this as well as a fuel pressure tester. If all checks out then move to the Turbo code.
Turbo code looks like the waste gate is stuck open and your not building the boost. Do a visual inspection look for any signs of overheating and bearing wear. Check or change oil as needed.
With regards to the Mass air flow I believe you have to replace it. Keep in mind this thing might be the root of you whole problem.
I strongly suggest you use the shop manual for the codes you got. it will make this repair a snap.

Oct 16, 2009 | 2007 Chevrolet Silverado 2500HD

1 Answer

My vw beetle stalls out. the mechanic first told


If it was the mass air flow sensor, you will have a check engine light. The small rubber hoses connected to/from the mass air flow connector might have come loose or have a crack, which will cause compression to be too low. Check there before replacing the maf sensor.

Aug 10, 2009 | Volkswagen Beetle Cars & Trucks

1 Answer

1999 New Beetle Turbo Check engine light and loses power


Change the air flow meter.That sounds like your problem.

Aug 07, 2009 | 1999 Volkswagen Beetle

2 Answers

2000 diesel beetle lost power still runs soso but acts like turbo not working i hear a loud hissing noise and ticking when punching. whats limp mode


Check and replace air filter and fuel filter with a additive,I sugest LUCAS FUEL ADDITIVE AND HEET IN THE RED BOTTLE.

Aug 07, 2009 | 2003 Volkswagen New Beetle Convertible

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76682 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...