Question about 1999 Cadillac Seville

Open Question

I need to know where the door module goes on the

Someone had worked on the door of my Cadillac and the module was just hanging I don't know exactly where or how it attatches to the door?

Posted by on

2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 314 Answers

SOURCE: I have a 2002 cadillac

The door module for that door is actually located inside of that door. You have to remove the door panel to gain access to it. Each door has it's own module on your car;)

Posted on Jul 31, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need to know which wire attaches to the top and which one goes on the bottom. rear passanager brake abs attachment has broken off and need to temp fix.

An ohm meter may help or hold the broken pieces together, exactly as it broke, the two pieces should line up to original position and give you an idea.
Hope either helps!

Apr 15, 2015 | 2000 Cadillac DeVille

1 Answer

I have a 20058 Cadillac CTS and the front windows won't go up or down. They are stuck down midway, both in the exact same spot. I checked the fuses, breaker, replaced the control panel on the door and...

Usually you have to disconnect the negative battery cable to put the modules in a "rest mode". After about an hour reconnect the cable to see if the windows work.

Jan 27, 2015 | 2005 Cadillac CTS

1 Answer

Process to replace liftgate actuator 2005 cadillac srx

Why do you want to replace lift gate actuator ? Do you know how this works ? Do you want to replace it on a hunch or did you test it.It is controlled by .The left rear door module .

Dec 26, 2014 | 2005 Cadillac SRX

1 Answer

I have a 2003 Cadillac Seville STS and the my air bag and brake light came on dashboard with a alert that said something to the effect of check rider system. Does anyone know what exactly this means.

It would have to scanned with a computer to see exactly what is wrong.It could be the sir module,passenger side airbag, front sensors, or a short in the wiring. Without codes this is as far I can go. Even with codes, sensors and wiring would have to be checked..But codes give you a direction to look.

Jun 22, 2014 | Cadillac Seville Cars & Trucks

1 Answer

My Cadillac STS 05 door got hit so i had to replace it with a new door i found at a junk yard. so i replace it and everything was working fine then i notice the lights were "Flickering" so i kept getting...

Take it an have vehicle scan done . Your vehicle has a vast amount of electronics , control modules , communication networks for the modules to share data on . All it takes is one of the wires touching ground to cause all kind of problems . There are modules inside the doors that control power windows , locks , mirrors etc. . Hooking up a scan tool that can check for communications from all modules . Not a code reader . A GM factory Tech 2 would be best . I work for Cadillac ,have for twenty years .

Jul 27, 2017 | 2005 Cadillac STS

1 Answer

I have a 2002 cadillac deville, The left rear window and lock don't work. Where is the door module location for left rear door. Any dianostic suggestions

The door module for that door is actually located inside of that door. You have to remove the door panel to gain access to it. Each door has it's own module on your car;)

Jul 31, 2011 | 2002 Cadillac Deville

1 Answer

.EVERYTHING is down on her.

There must be some short circuits in your car so, you have to check for broken or damaged wires all around in the car. This will solve the battery dying all the time. the display fades because of computer fault, you should take it to electricians it will cost a lot of money. The fuel door and trunk opened because of central lock ecu fault - need to replace that.

Jul 11, 2011 | Cadillac Eldorado Cars & Trucks

2 Answers

1988 cadillac sadan deville. i have replaced havc programer, climate control head, thermostat, back flushed heater core.still geting only cold air from heater and only at the floor vents, will not switch...

the vents that receive the blowing air is of course provided by the blower motor. The duct work the blown air goes through has doors that open & close for the direction you want the heated air to be directed to. A motor runs these doors so you may have a bad motor to the main door

Jan 08, 2010 | 1988 Cadillac Sedan DeVille

1 Answer

I'd like to know exactly what the power window control module looks like and where it is located behind drivers door panel.

Thank you for inquirering about my module location issue. I ended up calling a GM mechanic friend of mine and he helped me out. Thanks again and I will probably use your site again in the furture. Don

Mar 25, 2009 | 1991 Oldsmobile Ninety Eight Regency

Not finding what you are looking for?
1999 Cadillac Seville Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides