Question about 1988 Mercury Cougar

2 Answers

My 88 mercury cougar has no heat,

The blower works, but no heat, ther is no smell of antifreeze what so ever. a/c works really good...

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 181 Answers


Posted on Oct 27, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 11 Answers

Check the vaccumn operated valve on the heater hose. Make sure when you are running the car and change the temp from hot to
cold to hot again the the valve moves

Posted on Oct 07, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Smell antifrezze but cant find leak

I was having the same problem with my 97 Cougar. I kept lossing antifreeze from the coolant storage. It turned out that I had a crack in the intake manifold. After rereplacing the manifold, it stopped lossing the antifreeze. I don't know if this helps, best wishes.

Jun 05, 2012 | 1997 Mercury Cougar XR7

2 Answers

I need a diagram for an 88 mercury cougar v-8 for vacum lines

Have you looked around the engine compartment? Many vehicles have a sticker with the vacuum diagram on it somewhere there (usually on top of the radiator mounting frame, but sometimes on a fender well).

Dec 07, 2011 | Mercury Cars & Trucks

2 Answers

Blower motor removal in a 1999 mercury cougar

SECTION 412-02: Heating and Ventilation 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Procedure revision date: 02/8/2001 Blower Motor Removal
  1. Remove the footwell upper trim panel (passenger side).
    • Remove the pushpins.
  1. Remove the blower motor.
    1. Disconnect the electrical connector.
    1. Lift the securing tab, turn the motor approximately 30 degrees counter-clockwise and remove the motor.
  1. NOTE: Engage the securing tab for the blower motor.

Nov 12, 2010 | 1999 Mercury Cougar

2 Answers

White smoke coming out muffler

white smoke indicates that the engine has a leaking head gasket

May 24, 2010 | 1999 Mercury Cougar

3 Answers

A/c and blower does not work i have 14 vots to the fan but still wont work

If it has power you need to confirm if it has a good ground. If it does it may be a defective motor. If not it may just need a blower resistor or have a wiring problem.

May 19, 2010 | 1999 Mercury Cougar

1 Answer

1999 mercury cougar. 3 of my 4 blower settings for a/c stopped working 6 weeks ago and today the 4th went out. i had the blower test and is fine. I replaced the blower resistor and blower switch and still...

Make sure you contact a Mercury Dealer or Ford Dealer and run your vehicle ID number to see if it has a recall on the blower switch. I worked for Ford for years and I think I remember that vehicle having a blower switch and or relay recall. Some of these recalls did not expire and if that is the case it would not cost you anything to have this done. Good luck, hope this helped

Feb 06, 2010 | 1999 Mercury Cougar

1 Answer

Blower motor fuse is located 99 mercury cougar

SECTION 412-04: Control Components 1999 Cougar Workshop Manual REMOVAL AND INSTALLATION Blower Motor Resistor Removal
  1. Remove the upper footwell trim panel (passenger side).
    • Remove the pushpins.
  1. Disconnect the blower motor resistor electrical connector.
  1. Remove the blower motor resistor.

May 06, 2009 | 1999 Mercury Cougar

2 Answers

Heater/AC won't blow out air

blower motor is behind the glove box. also check the blower resistor it should be nex to the blower motor

Oct 02, 2008 | 1995 Mercury Tracer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

79865 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides