Question about Hyundai Elantra
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely
Posted on Jan 20, 2009
It is located under the alternator. If you are looking down at the engine, it is to the far left. If you are under the car it is to the far right before the oil pan.
Posted on Feb 09, 2009
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
Posted on Mar 16, 2009
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
Posted on Feb 07, 2010
With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.
Posted on Apr 09, 2010
Tips for a great answer:
Apr 18, 2015 | 2007 Hyundai Elantra
Aug 15, 2011 | 1998 Hyundai Elantra
Jun 28, 2011 | 1998 Hyundai Elantra
May 21, 2010 | 1998 Hyundai Elantra
May 05, 2010 | 2000 Hyundai Elantra
Oct 28, 2009 | 1995 Hyundai Elantra
Oct 01, 2009 | 2001 Hyundai Elantra
Jun 26, 2009 | 2004 Hyundai Elantra
May 09, 2009 | 1998 Hyundai Elantra
210 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: