Question about 1998 Oldsmobile Intrigue

1 Answer

Heat wont work on drivers side of car.Only blows cold air even when control setting is up to 90 degrees. Passenger side works properly.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 11,896 Answers

There is a flap inside the venting that directs the air. This vent can get stuck. It is controlled by a vacuum controlled actuator. It can be leaky or a hose is disconnected

Posted on Oct 06, 2009

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 24 Answers

SOURCE: heat works on driver side, passenger side blows cold air.

Did you check your coolant level or was it low and you added to it at some point? If so the system my need to be bleed or worst case the thermostat is going bad.

Posted on Jan 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blows heat on passenger side only . Blows cold air on drivers side only


A nice radiator and heater core flush should fix you up.

Nov 17, 2014 | Cars & Trucks

2 Answers

Where is the blend door actuator located on 03 Hummer h2. Driver side blows cold, passenger side blows hot


They are not vac on the h2. there is 2 for temp control, one for recirc and one for blend. check the hummer forum as there is a great read for it there. the driver side actuator is really ez as it's under the glovebox, 20 min fix. the rest take removing the whole dash but it's not that tough.

Jan 10, 2012 | 2003 Hummer H2

1 Answer

Heater problem, 2 left front vents on dash board are blowing ice cold air + right 2 vents are blowing hot air. is this a possible dial setting/button problem or actual haeater problem. heat was set @...


Most likly this van has seperate controls for driver and passenger heat and ac controls.If its blowing hot air your heat is working.These controls operate differant dampers that are electonicly controlled.If the dials arent working they would cause this problem.

Feb 12, 2011 | 2004 Ford Freestar

1 Answer

No Heat Passenger Side. I have a 1999 Cadillac Deville. The problem is I can't get heat on the passenger side. Air blows but it is cold. I do have heat on the driver?s side. My car has the spate...


Hello: You have a failed temperature control actuator for the passenger air mix door. Remove the glove box and the close out panel under the dash on the passenger side. You will see two silver rods going from the actuators (mounted on the top and bottom of the heater/a/c programmer) Turn key on (engine off) Turn the a/c heater control on. Go from 60 to 90 or 90 to 60 and watch the rods the one that doesn't move is the failed one. The actuator is held in place by two 7mm screws and one electrical connector. When installing the new actuator have the temp set at 60 when you hook up the linkage. The passenger side set at full cold.

Nov 16, 2010 | 1999 Cadillac DeVille

2 Answers

Driver's side air blowing warm, won't change


Sounds like there is a crack in the vent that leads to the drivers side, and hot air from the engine is leaking through.

Aug 29, 2009 | 2003 Hummer H2

1 Answer

2004 Chevy Silverado AC is blowing warm air on passenger side.


You have dual zones that are controlled by temperature actuators the passenger side has lost its memory or has gone bad you can put it in self programming by disconnecting the battery for ten minutes then hook it back up start the truck turn the temperature control on but do not touch any other controls let it go thru the self programming for about 6 to 7 minutes then select your temperature you want if it still does not work properly you may have a bad actuator or a bad connection at the actuator

Jun 03, 2009 | 2005 Chevrolet Silverado

1 Answer

Heat works on driver side, passenger side blows cold air.


Did you check your coolant level or was it low and you added to it at some point? If so the system my need to be bleed or worst case the thermostat is going bad.

Jan 02, 2009 | 2001 Jeep Grand Cherokee

2 Answers

AIR CONDITIONER ONLY BLOWING COLD ON ONE SIDE AFTER DISCONNECTING BATTERY


Turn your AC off. Turn the car off Crank the car turn ac on drivers side to 60 passenger side to 90 press auto wait 1 minute turn AC off (very important) turn car off turn car back on switch driver's side 90 passenger 60 press auto wait one minute turn AC off( very important) turn car off turn car on AC 70 both sides press auto your ac should be blowing cold If not, you have an expensive problem

Aug 25, 2008 | GMC Sierra Cars & Trucks

Not finding what you are looking for?
1998 Oldsmobile Intrigue Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...